Submit a question to our community and get an answer from real people.
Submit

Where is the crank shaft position sensor on a 2007 dodge caliber 2.0

Report as

The Crankshaft Position Sensor is located directly next to the starter.

1.On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
2.Remove the Structural Collar
3.Unlock and disconnect the electrical connector to the crankshaft position sensor.
4.Remove the crankshaft position sensor bolt.
5.Remove the sensor
Reverse Order to install except note that:

Use a twisting motion when installing the sensor.

Install and tighten the crankshaft position sensor bolt and tighten to 9 N·m (80 ±15 in. lbs.).

Helpful Fun Thanks for voting Comments (1)
Report as
do you have a picture
Report as
Add a comment...

The crankshaft position sensor on a Dodge Caliber 2.0 is in the rear of an engine's block, which is near the transmission. Check below an exhaust manifold and also a little bit to the left center of an engine block.

Helpful Fun Thanks for voting Comments (1)
Report as
do you think you could find a picture of it
Report as
Add a comment...

check behind the harmonic balancer it is the bottom pulley on your belt

Helpful Fun Thanks for voting Comments (3)
Report as
do you have a picture
Report as
if you go to the ask home page and type in "where is the crankshaft position sensor on a (place year, make, and model of your car here) it will give detailed instructions on placement how to check if its faulty and how to change it i hope this helps if not let me know and i will run down as many links as i can for you
Report as
http://www.fixya.com/cars/t10466255-crank_sensor_located_2007_dodge just a quick check and i found this put that in your address bar it has picture and instructions
Report as
Add a comment...
Do you have an answer?
Answer this question...
Did you mean?
Login or Join the Community to answer
Popular Searches