To curl dreadlocks, you need a spray bottle with some water, a few curlers and some tightening gel. Dampen your hair, then apply the tightening gel to the damp dreads. Wrap the dreadlocks tightly around the curlers all the way up to the root. Allow the dreads to dry completely before removing the curlers.Know More
Spray your hair with water using a spray bottle. It is important to start with damp hair before curling, but it is also important to make sure that the hair is merely damp and not wet. If the dreads are too wet, allow them to dry a bit before curling.
Spread a small amount of tightening gel evenly throughout your hair. The tightening gel serves to help the curls hold and keep the dreadlocks tight.
Wrap your locks around the curlers from tip to root. Use one curler for either one or multiple dreadlocks, depending on the thickness of your dreads and the length of your curlers. Tie each curler in place, securing it tightly. Repeat the curling process until all the dreads are wrapped around a curler.
Allow your hair to dry completely, either by air-drying or with the use of a blow dryer.
Untie the curlers, and let the curled dreadlocks fall naturally.
To curl hair with a wand, blow-dry the hair with a round brush, wrap 2-inch sections of hair around the wand, and apply hairspray. This 20-minute process requires heat protectant spray, a curling wand, a round brush, a blow-dryer, a clip and hairspray.Full Answer >
A texturizer is a chemical process that permanently modifies the state of hair. An S-Curl texturizer is a chemical by Luster that manipulates the natural texture or hair pattern to create a loose coil or wave. Luster’s S-Curl texturizer comes in a regular-strength kit and an extra-strength kit.Full Answer >
To curl hair with rollers, first choose the correct roller size. Use smaller rollers for defined curls and larger rollers to create waves and add body and volume. You need hair rollers, hair mousse, a blow-dryer and hairspray.Full Answer >
To curl hair with foam rollers, mist your dry hair with water, wrap each section around a foam roller, blow-dry your hair for 20 minutes, and remove the rollers. The supplies required for this 35-minute procedure are a hairbrush, a clean spray bottle, water, heat protection spray, foam rollers, roller clips, a hair dryer and hairspray.Full Answer >