To remove starter earrings, wash your hands, disinfect the ears, gently loosen the earring and slowly remove the backing. The process takes just a few minutes.Know More
Disinfect your hands and earlobes
Wash your hands thoroughly before starting. Wet a cotton ball or pad with rubbing alcohol, and gently wipe around the front and back of the earrings.
Twist the earring
Slowly twist the earring a few times while it's still in your ear. This helps loosen any skin that may have begun to attach to the stem.
Remove the backing
Pull the backing straight back to remove it. If it doesn't come off right away, rotate the backing a few times, and then try again.
Dish soap, warm water, a toothbrush and soft cloths are all the supplies needed to clean earrings. For most earrings, except pearls, a soak in mild detergent and warm water, a gentle scrub with a toothbrush and a drying buff with soft cloth are all it takes to restore their beauty.Full Answer >
Attach charms to French hook ear wires with jump rings to make simple, stylish earrings. You need a pair of French hook ear wires, a pair of charms, two jump rings and a pair of chain nose or bent chain nose pliers to complete this craft project.Full Answer >
Popular earring back designs include push backs, screw posts, latch backs, saddlebacks, lever backs and French clips. Push backs, also known as post or butterfly backs, are the standard design used on most stud-style earrings. A thin, straight wire is pushed into a small hole at the center of a butterfly-shaped back piece.Full Answer >
Typical earrings are gauged at either 18 or 20, depending on the particular piece of jewelry. Although gauge sizes can be as small as 00, 18 and 20 are the most common for new piercings so that a large amount of flesh is not removed from the lobe at once.Full Answer >