To roll your hair with spiral rods, brush it, fasten it into equal sections with butterfly clips, roll each section down a spiral rod, bend the rods until the ends cross, and leave them in for 20 minutes. This 45-minute procedure requires a hairbrush, alligator clips, spiral rods, hairspray and hair elastics.Know More
Brush your hair thoroughly. Divide it into even segments, and secure each with an alligator clip.
Release a section of hair at the front of your head, and spray both sides with hairspray. Hold a spiral rod next to that section, and wrap the roots of your hair around the top of the rod. Continue until all of the hair is wrapped around the rod, and secure it with a hair elastic at the bottom.
Hold one end of the rod in each hand, and bend it down toward your neck. Cross one end over the other to secure it in the proper position. Wrap and bend the rest of the rods in this manner.
Leave the rods in your hair for at least 20 minutes.
Unwrap the rods one at a time. Grasp the ends, unbend them, and roll the rod out of your hair. Set your curls with a light mist of flexible-hold hairspray.
You can wear perm rods by dividing your hair into sections and rolling the end of each section with a perm rod. When all hair sections are rolled, cover your head with a scarf. Leave the rods in your hair overnight. The curls set by morning.Full Answer >
To create compact curls that grows bigger, such as a curly Afro, take the ends of the hair, and roll upward until the curler reaches the scalp. Roll toward the floor, and keep the hair taut. For elongated coils like Shirley Temple's, start the wrap at the end that has the clamp. Roll in a slanted motion so that the hair wraps around the rod in a spiral.Full Answer >
To use cold wave hair rods, simply brush one inch sections of hair, secure hair sections on the rods and sleep with your head covered in a silk scarf. This process usually takes about 30 minutes of preparation and about eight hours for the hair to set.Full Answer >
Using perm rods begins with opening the rods, clipping sections of clean hair, combing the unclipped sections and wrapping the hair around the perm rod smoothly. The mechanism must be fastened by stretching it across the top of the perm rod and inserting a cap in the open end. The perm rods are used effectively on clean small partings.Full Answer >