To set the time on a Timex 1440 sports watch, push the mode button until the time shows. Hold the lap/reset button until the seconds begin to flash, and then push the start/stop button to change the seconds. Push the mode button to switch between seconds, minutes and hours, and push the lap/reset button at the end to confirm the settings.Know More
The mode button is in the upper left-hand corner of the watch face, the lap/reset button is in the bottom right hand corner, and the start/stop button is in the upper right hand corner. Press the mode button until the display indicates it is in time mode. Once in time mode, hold the lap/reset button until the seconds portion of the display begins to flash. Press the start/stop button to change the seconds, and press the mode button to set. The minutes portion of the screen will blink. Press the start/stop button to change the minutes.
Hit the mode button again to set the hours, and press the start/stop button to select the correct hour. Finally, hit the lap/reset button once, and the time is set. To change the date, push the mode button until the date mode appears on the screen. Press the start/stop button until the date is correct, and hit the lap/reset button to confirm the settings. This same process is used to set the alarm. First, use the mode button to select the alarm mode. Next, press the start/stop button to change the time until the desired alarm time is set. Press the lap/reset button to set the alarm.Learn more about Watches
To set the time on a digital watch, locate the Set or Mode button on the watch. Press the button until either the minute or hour unit begins to flash on the display. Use the Adjust button on the watch to set the correct time. Press the Set or Mode button to save the time.Full Answer >
To change the battery in a Timex Ironman watch, first remove the back of the watch. The back is held on by tiny screws. Remove the old battery, and insert the new battery. On some models this may require removing an additional screw.Full Answer >
A Timex WR50M refers to any wrist watch manufactured by Timex that has water resistance up to 50 meters. The “WR” stands for “water resistant.”Full Answer >
The crown of a watch is the button or small pin on the side of a watch face. It winds watches with a manual wind mechanism and it stops the watch when pulled away from the face which helps the battery last longer. The traditional functions of the crown are to wind the watch, stop the watch, change the date and to set the time.Full Answer >