CHRYSLER 2.5 FAQ

Frequently Asked Questions
1. Check the air filter by unlatching its housing located toward the front of the vehicle on the driver side. If the pleats of the air filter are soiled then the filter should be r...
1. Look for the engine block casting number. The casting number is on the back of the passenger side of the block, near the oil pan rail. The number is seven-digits long. 2. Write ...
1. Raise the car with the floor jack and support it by placing floor jacks under the sub frame. Lower the car onto the jacks and remove the floor jack. Remove the passenger side wh...
If equipped with a cabin filter, it is under the dash on the passenger side.
upsteam sensor may be in the exhaust manifold,down stream is after the cat., in the exhaust pipe.
Look down into the engine bay and the starter is behind the manifold on the right side of the engine. to replace.. 1. Disconnect the red lead on the battery. 2. Raise the front of ...
Look under the exhaust manifold on the side of the motor facing the radiator. You have to drop the manifold and the oil filter bracket to change it.
Answer This is something you cant do manually!It is controlled by sensors!
The turn signal flasher is located in the light control moduel. That is located under the steering column. If you are having problems with turn signals, check the fuses before chan...
The fuel filter is located above the rear of the fuel tank. You will need to drop the fuel tank down about 10 to 12 inches, as the fuel lines allow, and disconnect the three fuel l...
look in your manual's index under capacities and specifications. (or Engine Oil). Oil Capacity. The engine oil capacity with the filter is 4.5 Quarts.
it is an part of the distributor unit. you have to change out the entire distributor.
The engine thermostat is located in a thermostat housing, located below the throttle body. REMOVAL. Drain cooling system to the thermostat level or below. Remove inlet hose and coo...
To set the ignition timing, warm up the engine, loosen the distributor clamp bolt, unplug the coolant temperature sensor located on the drivers side of the thermostat housing. Be c...
Answer o n a dodge daytona the firing order goes from left to right starting with 1 then 2 then 3 then 4 set your rotor pointing towards cylider one with cylynder one in top dead c...
About -  Privacy -   -  Careers -  Ask Answers  © 2013 Ask.com