ISUZU 2.2L FAQ

Frequently Asked Questions
1. Locate the relay box near the driver's side fender well. Lift the cover off the relay box, then, using the diagram on the underside of the cover, locate the fuel pump relay. Pul...
1-3-4-2. Look at this: http://autorepair.about.com/library/firing_orders/bl-fo-4744.htm.
The starter is located on the passenger side of the block, kind of hard to reach and a pain to remove.
Cams will point straight up to match marks on housing and crank will be at about 1 o'clock where mark on crank pulley will line up with mark on oil pump casing.
Answer as far as i can tell ...it's on the back off the motor in the middle .. i can't get the bolts off ...and it's making me mad ....anyone know how i can get this dang thing off...
You didn't say whether you had a V6 engine or a 4cyl. Here is the procedure for a V6. It sounds like he moved the cam shaft independently of the crankshaft or other camshaft so you...
The spark plugs are under the plastic strip that runs up the middle of the valve cover.
Search on isuzupup.com some of those guys will sell their old parts or whole turcks. Check it out.
I can say that I had this issue as well. I found that the spark plugs were actually mounted directly to the engine. There are no wires to pass the charge, and the spark ignites dir...
look at the top of the engine, the cover for the spark plugs ends at the front of the engine. Right at that point is where the connector is, to get at the sensor you must remove th...
Directly on top of the motor. You need an Allen wrench to remove the black plastic panel from the top of the motor. Once you remove this cover, all (4) spark plugs are exposed. Not...
It depends, do you have an inline-4 cylinder 2.2L engine or the V-6 3.2L engine?
Hi, Isuzu seem to have complicated things by changing engines, firing orders and even direction of rotation! As you can see, they've numbered the cylinders the other way than the 3...
Rodeo go Two plugs that a 3/8 ratchet fit into on trans lower for drain upper for fill, after draining fill until fluid flows out upper plug, run the engine and cycle gears and do ...
The distibutor is not circular. All the wires are in a stright line, so I'm a little confused. I have found that the firing order is 1,3,4,2 if that helps.
All of it. You let him have a car and you know he is drinking/drugging? Believe me, as an attorney, I'm coming after the insurance and the parents. The kid doesn't have any money, ...
When using this website please use common sense. The information provided on this site is intended for your general knowledge only and is not a substitute for professional advice. ...
Answer look at the top of the engine, the cover for the spark plugs ends at the front of the engine. Right at that point is where the connector is, to get at the sensor you must re...
I have always been told it was because the fuel will expand and potentially overflow at some later time. This seems only logical when it is summer time and the inground fuel temp i...
I have always been told it was because the fuel will expand and potentially overflow at some later time. This seems only logical when it is summer time and the inground fuel temp i...
Answer Cams will point straight up to match marks on housing and crank will be at about 1 o'clock where mark on crank pulley will line up with mark on oil pump casing
About -  Privacy -   -  Careers -  Ask Answers  © 2013 Ask.com