ONKYO TX-SR505 FAQ

Frequently Asked Questions
Unless you have a Blu-ray player no difference at all. The only high definition source for audio is Blu-ray (and HD-DVD). Lets get a little more specific. CD audio is 16 bit 48KHz....
1. Cut a speaker wire long enough to connect from the TX-8211 to the subwoofer. Remove 1/2 an inch of insulation from the two wires on each end. 2. Connect the two wires on one end...
1. Press the "Power" button on the front of the receiver if you cannot turn it on with the remote. If the device turns on when you press its button, you'll need to replace the batt...
1. Place the WD HDTV Live near your Onkyo TX-SR608. 2. Connect the component cable into video slot on the back of the WD HDTV Live on the right side. Then connect the RCA cable dir...
1. Reset your Onkyo TX-SR805 receiver to remove faulty settings or unlock the receiver. Press the power button while holding down the "VCR/DVR" button. The display screen will show...
The Onkyo TX-SR606 is a 500-watt audio-video receiver for home theater. It can be used with digital or analog equipment and a 7.1 speaker system for surround sound. Like all Onkyo ...
Thats correct, THX certification, Sirius and PC inputs are the only differences. Unless you plan to buy THX certified speakers and cables I don't see a valid reason to buy the THX...
Going by Ebay prices, an ONKYO TX-2500 receiver is worth around $31.It depend...
The Onkyo TX-850 has a power rating of 68 watts per channel into 8 ohms, Federal Trade Commission (FTC) rated, 2 x 145 watts of dynamic power at 3 ohms. Dynamic power is the abilit...
The Onkyo TX-910 is rated to provide 45 watts per channel, for a total output power of 90 watts. This is based on an 8 ohm load with distortion of 0.3 percent or less. References: ...
To all the folks out there with Onkyo protection mode problems: Most likely you have shorted speaker wires either at the receiver or at/in the speaker. Protection mode prevents dam...
I'm sorry, I couldn't find any information on the TX-85221. Thanks... ...MORE...
SAME AS ANY TV,,RCA JACKS,,,OR HDMI,,OR COPONENT JACK,,,SHOULD HAVE ONE OF THOSE ON THAT TV,,GOOD LUCK
For the price, it's about the best out there. Onkyo is known for their audiophile quality amplifiers and quality electronics used in their components. A few other excellent choices...
Turning any receiver off will erase the settings - there is no backup battery (Onkyo uses Battery Free Memory Backup) and the length of time depends on the capacitor charge. Why no...
if what Dark_Orbit said does not work try doing a master reset by ressing and holding the dvr/vcr button and stand by button simultaneously. This would erase all your assignments s...
Depends what you're trying to do with two amplifiers. Fill in the intent piece.
I have a manual for this model that just died on me...would be happy to send it to you. Scotty D
Yes turing on the "A" speaker is required for the Onkyo, but that only turns on the 2 front speakers in the "A" speaker jacks. You may also need to check and see if the Onkyo has a...
If you look on the internet HDMI board failure on these Onkyo's seems quite a regular occurence. Time to scrap the Onkyo and buy something with a better name - like Yamaha, Denon o...
Could well be the quality of your cables. if you have high end cables the consult a service agent. if you have the cables that came with the products, go and get some better ones.
Hold Video 1 and Press the power button then turn it back on i had the same problem
I think it could be done if a version is/was made for the higher voltage market (240 volts?). All that would need to done is replacement of the power supply section parts with the ...
Overall Rating: User Rating 1 Star Rating star(s) Reader Reviews: Submit a Review of Your Home Theater Receiver
About -  Privacy -   -  Careers -  Ask Answers  © 2013 Ask.com