PENTAX K-X FAQ

1. Clean the Pentax K1000 thoroughly. The camera body may be approximately 30 years old, so dust, dirt and debris have had a long time to build up in it. Take the lens off the came...
1. Replace the AA batteries currently in the camera. Even if you did not take a lot of pictures the last time you used your Pentax, these batteries are notorious for losing their c...
1. Take a lot of rolls of 35 mm film with you and get outdoors. Go some place you haven't been before and shoot a lot of photos quickly. You will go through film rapidly this way, ...
1. Plug the battery charger power cable from a wall outlet to the battery charger housing. Insert the Pentax K10D D-LI50 battery into the charger so the arrow mark is facing up. Th...
1. Set up a clean area indoors. The biggest enemy to keeping a CCD clean is dusty, windy areas. Make sure you have a rear lens cap or a plastic cover for your lens. 2. Turn the cam...
1. Check to see that the batteries are positioned correctly if the camera does not turn on. Re-insert the batteries according to the +/- symbols. 2. Set the aperture to the "A" pos...
1. Install a new battery and empty memory card into the Pentax K200D. Rotate the power switch, located just under the shutter release button, to the "On" position. 2. Press the men...
1. Turn the camera on. Press the "Menu" button on the back of the camera. Use the round directional button on the back of the camera to scroll through the menu to "Rec. Mode." Scro...
1. Turn the "Mode" dial, located on top of the camera to the left of the flash mount if you're looking at the camera from behind, to the green square icon to put your camera in aut...
1. Check that the battery is charged and inserted correctly if the camera will not power on. Lift the battery unlock lever, turn toward OPEN to unlock, and then pull the cover open...
1. Hold the Pentax K1000 in your hand and lift the ring that surrounds the shutter speed dial. Rotate the dial to set the camera to match the film speed of the film that is loaded ...
1. Open the back of the camera. Do this by pulling up on the camera's rewind knob. That knob displays an "R" and a clockwise-pointing arrow. For a picture of the camera and its par...
1. Hold the camera upright in your right hand. Locate the film rewind knob on the top left of the camera. Pull the knob straight up. This will release the camera back, allowing you...
1. Turn the round selector switch on the top of the camera to the "Auto Pict" setting. 2. Switch the focus mode lever at the bottom of the camera--next to the lens--to the "AF" pos...
Pentax created the original K mount, and it has made many cameras over the years that have the K mount for lenses. Pentax K-series, M-series and LX body cameras have the original K...
1. Turn on the camera and wait at least 2 seconds before taking a picture. The "Shake Reduction" feature will not work unless you wait 2 seconds when powering on. 2. Push the "Shak...
1. Open the battery compartment cover on the underside of the camera and insert two fresh AA batteries. Close the compartment so that it clicks into place. 2. Slide the memory card...
The Pentax DSLR K10D is a digital SLR camera. It is on the lower end of the SLR cameras provided by Pentax, because the lens provided is on the small side (the lens is the most exp...
1. Holding the camera in one hand or resting it on a table, slide the release tab on the top right of the camera to unlock the back film door and open the camera. 2. Press and shif...
1. Mount the 2x teleconverter onto your Pentax DSLR. Choosing a teleconverter that is manufactured by Pentax is best as it ensures mounting compatibility with the camera body and t...
1. Set the mode dial located on the top left side of the Pentax K100D camera body to "M" (manual). 2. Set the ISO setting, which controls the camera sensor's sensitivity to light. ...
1. Turn your Pentax K10D on. Press the menu button located on the top left of the back of the camera, select "ISO" from the menu and change the setting to "100." Press "OK" in the ...
1. Turn the power switch on the Pentax K200D and the Nikon SB-28 to the off position. Slide the Nikon SB-28 external flash onto the hot shoe located on the top of the Pentax K200D....
1. Clean your M-series lenses if they have been sitting around for a long time. Use compressed air on the external sides of the lens elements--both front and rear--to avoid damagin...
1. Turn the "Power" switch to the "On" position. The power switch is on the top, right side of the camera, around the shutter button. 2. Twist the "Mode" dial on the upper left sid...
1. Push and hold the battery door unlock lever (located on the base of the camera). Slide the door towards the lens until it clicks open. 2. Remove the four AA batteries from the b...
1. Turn off the camera. 2. Attach the lens to the body using the red dots on the lens and the body as a guide. 3. Spin the lens clockwise until it twists into place. You will hear ...
1. Slide the Wein Safe Sync onto the Pentax K100D hot shoe. Slide the Vivitar flash onto the Wein Safe Sync hot shoe and connect the flash to the Safe Sync by plugging the sync cor...
The Pentax K1000 uses 35mm film and accepts Pentax K-mount and compatible lenses. Its shutter speeds range from 1/1000 of a second to 1 second, with a bulb setting for longer expos...
1. Make sure the camera is off. The main power switch is on the top-right side of the camera body. Move it to "OFF" position to turn off the camera. 2. Align the red dots on the ca...
About -  Privacy -   -  Careers -  Ask Answers  © 2013 Ask.com