WHITE-RODGERS THERMOSTAT FAQ

Frequently Asked Questions
1. Locate the "Menu" button at the bottom of the thermostat screen. 2. Press and hold the "Menu" for roughly 20 seconds. The "Menu" button will disappear while you are holding it d...
1. Look at the back of the thermostat if you have not used it yet. The White-Rodgers company includes batteries with your purchase. On the back, you will see the battery compartmen...
1. Turn the power breaker to the existing thermostat off. 2. Pull the top of the thermostat cover with one hand while holding the base with the other hand to release it. Pull the c...
1. Verify that the household power supply hasn't been interrupted if there's no heating or cooling. Check the home's breaker panel and look for tripped breakers or blown fuses. Che...
1. Push the "Set Clock" button on the thermostat control panel to start programming the current time and day. The minutes unit will appear on the LCD screen. 2. Advance or reverse ...
1. Turn off the air handler's power off at the breaker box. 2. Take off the top of the White Rodgers thermostat. Remove and label each wire on the old subbase (bottom part screwed ...
1. Turn off the power supply at the household breaker box. 2. Remove the old thermostat cover. Locate and label all wires with the terminal that the wires were attached to in the o...
1. Turn off the circuit breaker or disconnect the fuse that controls the inside unit of the heat pump system. The correct circuit breaker or fuse uses a "Furnace" or "Air Handler" ...
1. Pull the cover off the old thermostat and remove the captive screws that secure the base plate to the wall with a screwdriver. Remove the screws from the switching sub base to e...
1. Turn off the power to your heating and air conditioning system. The circuit breaker is located in the electrical panel box. Switch the breaker to the "Off" position. 2. Remove t...
1. Turn off the power to the heating system at the circuit breaker box. Place a label on the breaker so that someone does not turn it on while you are working on the system. Remove...
1. Turn off the circuit breaker to the AC/heating unit. 2. Remove the cover of the thermostat. Some models of White-Rodgers thermostats pull straight off, while others have two scr...
1. Shut off the electricity for the device (such as a furnace or boiler, for example) at the main panel. 2. If applicable, remove the old thermostat cover. Do not disconnect the wi...
Take a look here...if all else fails give them a call. White-Rodgers 90 Series® Blue Touchscreen Thermostats A short how to: http://www.white-rodgers.com/wrdhom/ther… Installation ...
1. Shut off the electricity to the furnace while replacing the rollout limit switch. Check for a dedicated "On/Off" switch on or near the furnace. Open your electrical service pane...
1. Press the "Set Time" button. The hour will appear. 2. Press the up or down arrow to reach the appropriate hour (a.m. begins at midnight, and p.m. begins at noon). 3. Press "Set ...
1. Turn off the electricity to the unit (boiler, water heater, etc.) in question, preferably using the electric switch mounted to the unit itself. 2. Loosen the screw under the Whi...
1. Put your safety gloves on and remove your trailer's heater furnace panel. On most furnaces, the panel will simply pop off. On some, though, you may need to use a screwdriver to ...
White-Rodgers thermostats are manufactured by Emerson Electric Co. There are various models of thermostats available. Each of the models uses two AA batteries. The batteries are in...
If the fan runs all the time. Two things come to mind here. Either A. the thermostat is set up in the advance installer settings and has been set to run the fan ALL the time. B. Yo...
1. Turn the thermostat off. 2. Remove the thermostat cover from the wall. 3. Locate the battery compartment along the top of the unit. 4. Remove the old batteries from the unit. 5....
1. Turn off the power supply to the heater at the main electrical box. 2. Test the supply wires using a voltage tester to ensure there isn't any power. 3. Strip 1/2 inch of insulat...
Not real familiar with the 1f80-51,but most w/r tstats can be hard wired with a common wire to c post,and this will do away with the need for using batteries,they then work off the...
Steps that you need to do. First is to reset the unit by pressing the reset button for two seconds right below the fan switch. Second is to re- program the thermostat correctly, ma...
many white rodgers tstats require batteries to operate. I've seen low batteries cause several strange behaviors. There are "change battery" indicators on the tstats but often the b...
You mean there is no manual override ? If not, it may be easier to find how to do a manual override than trying to guess what transmitter they use and what encryption they use. Fin...
Get a larger-capacity AC system. Actually, if you understood refrigeration and were to think of all the details correctly, you would realize that no matter how powerful the AC syst...
A phone number is not listed.However if you refer to the referenced websit...
About -  Privacy -   -  Careers -  Ask Answers  © 2013 Ask.com