The dihedral shape of a paper airplane's wings and the angle of its rear elevator flaps affect how it flies. The rear elevator wings, in particular, can be adjusted to make a paper airplane lift, dive or curve to the left or right.Know More
It's recommended that a paper airplane's wings be dihedral. This means that they have a slightly upward tilt. When viewed from the front, the wings should then resemble a slight V shape. Having dihedral wings gives the paper airplane more aerodynamic stability in flight. If the wings are flat, though, the paper airplane can't naturally stabilize itself once it is released from the hand. Because of this, paper airplanes with dihedral wings perform better flights.
Elevator flaps can also be very consequential to the performance of a paper airplane, depending on how they are designed. The elevator flaps are typically installed in the rear edges of the wings by making small parallel cuts that should be about an inch apart. The flaps can then be folded in different configurations to adjust the flight. If the flaps are folded upwards, for instance, the plane will gain altitude. Conversely, if the flaps are folded down, the plane will dive. Also, the elevator flaps can be adjusted to give the paper airplane an inclination towards a certain direction. By adding more elevator to one wing over the other, the plane will turn in its flight.Learn more about Paper Crafts
A5 paper has dimensions of 5.8 inches wide by 8.3 inches long. This is equivalent to 148 millimeters wide by 210 millimeters long.Full Answer >
Make a butterfly by cutting a paper plate in two for the wings and pasting them onto an empty toilet paper roll. This craft requires a paper plate, a toilet paper roll, paint, wiggle eyes, pipe cleaner, scissors, a paint brush and glue.Full Answer >
Heat transfer printing uses a heat press to transfer a design to objects such as clothing or textiles. Some examples are heat transfer vinyl, commonly used on athletic uniforms, and special effect heat transfers like glow-in-the-dark or reflective designs.Full Answer >
The simplest way to make stencils is to apply the design to stiff polyester plastic sheeting, and then cut out the stencils with a craft knife. The easiest way to prepare the design is on a computer. Design the stencil to appear exactly as needed, including the final size. Print the design out, and trace onto the plastic sheeting.Full Answer >