Use the crochet hook that came with the loom kit to gradually crochet all four edges of loops together into a completed edge. Do not forget to leave the last loop free in order to hang it when the pot holder is not in use.Know More
Finishing a pot holder made on a small peg loom involves creating a crocheted edge.
Step 1: Choose an edge to start
Start along one side of the loom and remove the two loops on the end of that side from the pegs.
Step 2: Begin the crocheted edge
Grasp the second loop. Push the crochet hook that came with the loom through the second loop and hook the first loop. Pull the first loop through the second loop's opening.
Step 3: Finish the stitch
Release the first loop from the hook and gently pull the second loop to tighten it.
Step 4: Repeat the crocheted stitches
Put the first loop back onto the peg and repeat the crocheting process along the edge of the pot holder.
Step 5: Continue with the other three edges
Crochet the other three edges in the same way. When there are two loops left, crochet them and pull the last one tight and a little farther from the pot holder to create a hanging loop.Learn more about Crafting
To make your own knitting loom, you need a pen or pencil that can leave marks on ring material. You also need a ring, rubber and tape.Full Answer >
Make an easy single chain loom band bracelet on a loom or with your fingers using only 25 stretch bands and a stretch band clip. The process takes less than 10 minutes.Full Answer >
Joseph Marie Jacquard invented the Jacquard loom, which was a mechanical loom, in 1801. Other looms include the dobby loom, the backstrap loom, the foot-treadle floor loom and the horizontal ground loom.Full Answer >
To make a simple beading loom, attach two smaller pieces of wood on either end of a wooden base, and attach two large eye hooks on each of the smaller pieces of wood that support the bolts that the beading thread runs across.Full Answer >