To make a peg loom, gather a wooden dowel, a piece of timber, a drill and drill bits. Cut the wood to the size you want. Drill holes into the piece of wood, and stick the wood pegs into them.Know More
You need a long, round wooden dowel and a rectangular piece of wood. For tools, you need a drill and a wood drill bit. A vice is also helpful.
Cut the round dowel into several pieces of equal lengths. The number and size depends on what you want to use the peg loom for. In one end of each dowel, drill small holes wide enough for your yarn to go through.
Cut the piece of timber to be slightly wider than the desired width for the loom.
The timber is the base of the loom. Measure and mark where the holes are to be drilled along the base. They should be evenly spaced. Drill holes just slightly wider than the width of the round dowels. You want it to be a snug fit for the dowels.
Place the dowels in the holes of the piece of wood that forms the base. The end with the hole in it goes in the base. Make sure that they fit snugly and that the small holes are visible.
Make an easy single chain loom band bracelet on a loom or with your fingers using only 25 stretch bands and a stretch band clip. The process takes less than 10 minutes.Full Answer >
To make bracelets on a Rainbow Loom, hook stretch bands on the pegs in various patterns. You can make a simple single chain bracelet in about 15 minutes.Full Answer >
To make your own knitting loom, you need a pen or pencil that can leave marks on ring material. You also need a ring, rubber and tape.Full Answer >
Once you have finished a potholder, you need to create a crocheted edge as you take it off the loom. You can use the hook tool that comes with the kit, but a crochet hook usually works better. Either way, taking your finished potholder off of the loom is a fairly easy process.Full Answer >