Fingerless gloves can be made by starting out with 24 rows of knit stitches and creating the fingers from the base of the gloves by knitting in various lengths of rows. The gloves will be made by taking breaks in the knitting and cutting off yarn where the fingers would normally be located.Know More
After completing the initial row of 24 stitches, create 15 rows of rib stitches. The next 12 rows should be a stockinette stitch and should always end in a purl stitch with the every other stitch being a knit stitch. The next four rows should revert back to a rib stitch. Cut the yarn off and tie it with an 8-inch tail. Then, fold the piece of stitches in half and use a yarn needle to sew the two edges together.
The place where the two edges are sewn together will be the spot for the thumb hole of the fingerless glove. Match the other fingers together,sewing them using a yarn needle. The pieces will form the holes for the fingers. Trim any loose ends and pull or add any additional stitches if the finger holes are not big enough.Learn More
Finger knitting a scarf is the process of making a scarf out of yarn by using your fingers to loop the yarn into a pattern. Finger knitting is a way to knit without using traditional knitting needles.Full Answer >
To finger knit a chain, weave the yarn over and under the fingers twice, loop the yarn all the way around the fingers, pull the loops over and continue the process until the desired length is achieved. Finger knitting takes a few minutes to an hour, depending on the project, and it requires yarn and scissors.Full Answer >
Jim Beam bottles can be used as a base for several craft ideas, from candle holders to soap dispensers. A popular item is a lamp made from a Jim Beam bottle. Making a Jim Beam bottle lamp requires the bottle, a lamp set, a lamp shade, a light bulb and a drill with a diamond-tip bit. The project should take less than an hour.Full Answer >
Two primary ways of making a duct tape bracelet involve using either paper or electrical wire as the base. Choose the length that you need, then wrap duct tape pieces around the base to form the bracelet. To add fun colors and designs to the bracelet, use duct tape in multiple colors and styles.Full Answer >