Q:

How do you adjust a sump pump float?

A:

Quick Answer

After turning off the electrical connection to the sump pump, unfasten the connector that holds the float to the cord, then add water to the sump pump hole until the pump is activated and adjust the cord until the pump turns off properly. The way that the float fastens to the cord will vary with different types of sump pumps.

Know More

Full Answer

A sump pump regulates the amount of water that is running into a building. Sometimes the cord that holds the float in the sump pump is too tight or too loose, which will make the pump never start or never stop pumping. To fix the float position in the pump, use the following directions.

  1. Disconnect the power to the pump and prepare to work
  2. Disconnect the power to the pump by unplugging the power supply. It is wise to wear rubber-soled shoes or boots so that there is no risk of getting shocked.

  3. Disconnect the float from the cord
  4. Unfasten the float from the cord that it is tethered to. The fastening mechanism will be different for different sump pumps.

  5. Turn on the pump and adjust the cord
  6. Pour water into the sump pump hole until the pump starts to activate. If the pump never turns on, then the cord needs to be tighter. If the pump never turns off, then the cord needs to be loosened. Adjust the cord until the pump turns on and turns off properly.

Learn more about Plumbing

Related Questions

  • Q:

    Why does my sump pump run all the time?

    A:

    Sump pumps run continuously for many reasons; however, if the pump was operating normally and the problem is recent, the most likely cause is a stuck float switch. This switch moves up with rising water levels to complete the circuit and start the pump. It then moves back down with the water level to break the circuit and shut off the pump, but obstructions prevent normal operation.

    Full Answer >
    Filed Under:
  • Q:

    How do you make a sump pump battery backup?

    A:

    To make your own sump pump battery backup for your home, you need a battery and an inverter. Pre-made sump pump backup systems are available for purchase, but you can make a homemade battery backup if plugging into a generator is not an option. Since you are working with electricity, be sure to take the same safety precautions as with any electrical project.

    Full Answer >
    Filed Under:
  • Q:

    How do you stop a sump pump discharge pipe from freezing?

    A:

    To help ensure that a sump pump discharge pipe doesn't freeze, bury the pipe 5 inches below the frost line or extend the pipe, if it's above the ground, away from the foundation at least 10 feet. Another anti-freezing option is to insulate the discharge pipe and the intake section.

    Full Answer >
    Filed Under:
  • Q:

    How do you troubleshoot a water well pump?

    A:

    In order to troubleshoot a water well pump, follow the troubleshooting tips outlined in the owner's manual. Ensure the power is off at the breaker before performing any troubleshooting tasks.

    Full Answer >
    Filed Under:

Explore