Q:

How do you adjust a water pressure-reducing valve?

A:

Adjust a water pressure-reducing valve by loosening the lock nut and turning the adjustment nut counterclockwise to reduce the pressure or clockwise to increase it. Install a pressure valve on an outside or laundry faucet to ensure the pressure is set to an appropriate range.

A lack of water pressure causes fixtures to run slowly. Too much pressure often results in leaks and humming pipes. Some plumbing systems give some control over the water pressure with a water pressure-reducing valve. When adjusting the valve, the final pressure should remain between 50 and 60 pounds per square inch.

Adjusting the pressure-reducing valve does not remedy problems due to the supply line. Most municipalities provide consumer information concerning pressure at which the water system operates. If the supplied pressure is greater than the desired range, the valve is useful in adjusting it to an appropriate flow.

If the plumbing normally operates at an acceptable range, but the home experiences a sudden drop in pressure, the problem is normally not with the pressure valve. A break in a line or a problem at the pumping station is usually responsible for the pressure drop. In such cases, the best approach is to wait until the municipality fixes the external problem, leaving the valve at its current setting.


Is this answer helpful?

Similar Questions

  • Q:

    How do you adjust a Square D well pressure switch?

    A:

    Adjust a Square D well pressure switch by turning it clockwise to raise the pressure and counter-clockwise to decrease the pressure. Prior to adjusting the switch, follow safety precautions and look for any faults in the switch components. Adjusting the Square D well pressure switch increases the water pressure through the entire house.

    Full Answer >
    Filed Under:
  • Q:

    What is a water shut off valve?

    A:

    A water shutoff valve refers to a small local valve that is used to control the water flow to a plumbing fixture. This type of valve is commonly found under the sink or under the toilet tank.

    Full Answer >
    Filed Under:
  • Q:

    How can I adjust the toilet water level?

    A:

    Adjusting the toilet water level involves adjusting the float valve. This valve regulates water flow into the tank to ensure the water level is at the best level for optimal toilet flushing. There are two primary float valve types — concentric valve type and the ball-cock valve type — both of which require the removal of the tank cover to gain access.

    Full Answer >
    Filed Under:
  • Q:

    How do you adjust the water level in a toilet bowl?

    A:

    The water level in a toilet bowl is adjusted using the fill valve. The fill valve determines the water level by controlling the position of the float. Raising the float arm increases the amount of water in the bowl while lowering it decreases the level of water.

    Full Answer >
    Filed Under:

Explore