According to About.com, if your air conditioner keeps blowing fuses or tripping circuit breakers, it is because the appliance is trying to draw more current than the fuse or breaker will allow. This can result from a window-mounted air conditioner being plugged into a circuit that is insufficient for its needs, or it could indicate that the air conditioner needs servicing.Know More
Circuit breakers and fuses are rated for a certain number of amperes. If the current goes above the rated amperes for more than a few seconds, the mechanism breaks the circuit. This is to prevent the excess heating that overcurrent can cause in the wiring and ultimately prevents fires. If an air conditioner's circuit is simply not powerful enough for its needs, the fuse blows every time the unit is started.
When an air conditioner begins blowing fuses while connected to a properly rated circuit, it could indicate a problem with the compressor. If the compressor has difficulty starting up, it can increase the amount of amperes the unit attempts to draw, overpowering the circuit and blowing the fuse. In any case, blown fuses should not be ignored. The unit should be checked by a professional to prevent a possible electrical fire.Learn more about Appliances
An air conditioner thermostat is a device which displays room temperature while working in tandem with the air conditioner. Thermostats can be used to automatically adjust the temperature in a room or to gauge temperature for manual adjustment.Full Answer >
Cooling a 600-square-foot room requires an air conditioner with a cooling capacity of 14,000 BTUs. Choosing a unit that is too large or small for the space results in inefficient cooling.Full Answer >
An air filter is located above the evaporator coil in an air conditioner, typically in a special slot within the duct system or inside the return grille. The air filter is made of paper and is either folded fuzzy-looking.Full Answer >
To repair a Goodman gas furnace, check the fuses and circuit breakers, clear the debris from the filter and clean the flame sensor. Other potential repairs include removing blockages from the flue and switch hose, adjusting the gas pressure and replacing the igniter.Full Answer >