Connecting a washing machine is a simple process, especially if it is just replacing an existing washing machine. Replacing a washer consists of only three steps and uses only water pump pliers and a level. Before connecting a new washer, the proper plumbing and electrical connections must be installed. However, the steps after that point are the same. Remember to turn off the water and electrical connections before installing any washing machine.Know More
The standpipe is where the used water goes after it drains from the washing machine. The standpipe must be connected to a drain or run into a laundry sink to utilize that drain. The standpipe should be larger than the drain hose, and the top should be located above the washer's water level.
Hook the hot and cold water hoses into the corresponding water valves. Tighten the hoses with water pump pliers. Turn the water and electricity to the washer back on. Turn on the valves, and let the washer basin fill. Then, check for leaks in the hoses.
After checking for leaks and ensuring that all the hoses are properly installed, use a builder's level to make sure that the washer is evenly placed on the floor on all sides. Adjust the feet of the washer as needed to prevent the machine from rocking during use.
To descale a washing machine, pour 1 cup of white vinegar into the drum, then let the empty washing machine run through one cycle with two rinses. Wipe the interior with a washcloth, then allow the machine to dry overnight.Full Answer >
According to Simply Good Stuff, dirty residue in a washing machine is usually caused by either insufficient cleaning or mechanical failure. Simply Good Stuff notes that better cleaning, as well as vigilant inspection of the washing machine, can help eliminate dirty residue.Full Answer >
The most common reason for a washing machine to smell like mold is the build up of mold or mildew underneath the rubber gaskets in the machine. This occurs when the rubber gaskets are worn down to the point where moisture leaks behind the gaskets and becomes stagnant. This issue can be easily remedied by replacing the rubber gaskets.Full Answer >
A common cause of lint in a washing machine is using the wrong load size. If the water level is too high, the clothing moves too much in the tub, causing lint. If it is too low, the overloaded machine is unable to rinse the lint away.Full Answer >