To disconnect a gas dryer, take the hose off the gas outlet and from the back of the dryer. Disconnect the flexible duct hose that connects the dryer to the exhaust vent. Place the hose and the ductwork inside the drum if you are planning to move the dryer.Know More
Turn off the gas at the valve in the laundry room by turning it clockwise until it stops. Disconnect the supply hose from the outlet and then from the rear of the dryer. Ensure that the gas is off before removing the hose for safety purposes.
Remove the ductwork from the back of the dryer and from the connection point with the wall. Remove any tape that is necessary. Hold one end of the ductwork in each hand, allowing the middle of the ductwork to sag downward and keep lint and other debris from spilling out onto the floor.
Put the hose and ductwork carefully into the drum of the dryer if you are preparing to move the dryer. Close the door securely so that it does not pop open and cause an accident during the moving process.
To install a gas dryer, a total of 10 steps must be completed, explains DoItYourself. Turn off the gas, install the gas connections for a gas dryer, shut the electrical power off, check the vent hole, clean up, use the pipe dope, check for leaks, fasten the vent hose, plug in the gas dryer and turn it on.Full Answer >
If a home has a gas line hookup in the laundry area, it is equipped for a gas dryer. If the laundry area has a 240-volt outlet, it is equipped for an electric dryer. A 240-volt outlet is larger than normal and is twice the strength of a normal household outlet. If neither is present, either a gas line or a 240-volt outlet can be professionally installed.Full Answer >
To connect a gas line to a dryer, you need a tape measure, a wire brush, a flexible gas hose, gas-rated pipe tape, a rag, a pipe wrench, a spray bottle and detergent. Use caution when installing the hose.Full Answer >
To troubleshoot a Whirlpool gas dryer, identify the type of problem the unit is experiencing. If there is very little heat, then there can be a problem with airflow. However, if the dryer is not heating at all, the problem is likely due to a faulty electrical part. To troubleshoot, start by testing the dryer's igniter, flame sensor and valve.Full Answer >