To fill a torch lighter, locate the refill nozzle, drain the existing fuel, shut off fuel flow and refill using a fuel refill can. Allow the lighter to rest before adjusting the flame to the desired height.Know More
Locate the refill nozzle, which is usually at the bottom of the lighter. The flame adjustment screw should be at the opposite end of the refill nozzle.
Use a small screwdriver or pen to depress the fuel nozzle, so as to empty the remaining fuel. Ensure that the refill nozzle is pointing downwards for efficient draining.
Look out for the "+" and "–" signs near the fuel adjustment screw. Turn the screw all the way towards the "–" sign to cut off the fuel flow.
Use a fuel refill can to refill the lighter. Turn the lighter up-side-down, and press the can straight down into the refill nozzle. Hold the can in position for about 15 seconds, and avoid pumping the fuel into the lighter.
Wait a few minutes or until the lighter reaches room temperature. Wrap your hands around the lighter to speed up the process.
Adjust the desired flame height by turning the flame adjustment screw toward the "+" sign. Start with a half turn, and light the lighter. Continue turning the screw slightly until the desired flame height is achieved.
Clean and fresh regular unleaded gasoline should be used on a four-stroke engine. The gasoline should be a minimum of 87 octane, and up to 10 percent ethanol or 15 percent methyl tertiary butyl ether is acceptable for use.Full Answer >
The fuel mixture for a Homelite 240 chainsaw should be at a ratio of 32:1. For every 32 parts of gasoline, one part should be two-stroke oil.Full Answer >
All gas-powered Stihl equipment runs on a 50:1 mixture of gasoline and two-cycle engine oil, according to the manufacturer's website. Stihl recommends the use of gasoline with no higher than 10 percent ethanol content.Full Answer >
Brad nailers and finish nailers can be compared based on the size of nails they use and the type of woodworking projects for which they are appropriate. Brad nailers use brads made of 18 gauge wire, which is thinner than the 15 and 16 gauge wire used in finish nailers. Carpenters often use a brad nailer to attach small moldings and trim to keep them from splitting.Full Answer >