A door may pull away from the hinges because of its weight or an unaligned strike plate. Swelling or settling of the house may also cause doors to shut improperly. Repairing it ensures a proper fit.Know More
Open the door and locate the hinge screws. Starting at the top, tighten the hinge screws with a screwdriver. If any screws are loose and fail to tighten, insert a wooden stick into the hole, wedging it between the screw and the hinge. Test the door when all screws are tight. Adjust if needed.
Locate the point where the door sticks. Drive a finishing nail into the jamb at this point, drawing the jamb closer to the framing. Use a nail punch to sink the nail. Fill the hole with wood putty. Sand and paint the patched hole.
Mark the point on the door that is sticking with a piece of tape. Remove the door from the hinges. Place the door on a pair of sawhorses. Plane the marked area with a hand plane. Sand away any roughness and touch up with paint. Rehang the door.
If the strike is out of alignment, unscrew it from the jamb. Fill in the area with epoxy putty. Finish by reinstalling the strike.
Fixing a door can be fairly simple or it may take a lot of work, this will depend on what is wrong with the door. A simple fix is that a screw is loose on the deadbolt and just needs to be tightened.Full Answer >
The fix for a warped door depends on the severity of the warp. If the door has a slight warp, things like shimming the hinges, adjusting the latch or adding a third hinge can rectify the problem. If the warp is too bad for these fixes, it can be straightened using weights, or planed.Full Answer >
To fix a car door that won't shut, force the door clasp into the open position with a screwdriver or other long, narrow object while the handle is held open. Most car doors fail to shut when the door clasp has been forced into the closed position and will not respond to the inner or outer handle.Full Answer >
Fixing a cracked door frame properly largely depends on the severity of the crack. If the door has a small crack that is simply cosmetic in nature, it can be filled with a bit of wood putty and covered with a little paint or varnish. If the crack is larger, the project will be a little more labor intensive.Full Answer >