Q:

How do you fix a leaky outdoor faucet?

A:

To fix a leaky outdoor faucet, turn off the water supply, unscrew the faucet handle and spigot, check if the washer lays properly in the spigot, and replace any damaged spigot washer, valve system washer or the valve stem. Turn on the water to check if the repair was successful.

  1. Remove the faucet handle and spigot

    Shut off the water supply to the faucet, and undo the faucet handle with a screwdriver. Then turn and remove the faucet spigot with a crescent wrench. Check if the washer is properly sitting in the spigot, and examine the washer for any damages.

  2. Replace the washer if needed

    Scoop the old washer from the spigot with a flat screwdriver, and insert a new washer into the spigot. Place back the handle and spigot onto the faucet, and turn on the water to test the faucet.

  3. Replace the faucet valve system washer

    If necessary, detach the handle and spigot from the faucet again, loosen and remove the packing nut with a crescent wrench, and remove the faucet valve mechanism. Remove the washer from the valve system, and insert a replacement washer. Check and replace the damaged faucet valve stem as needed.

  4. Reassemble the faucet

    Reattach the valve system to the faucet, replace the packing nut, and lubricate the nut and washer with grease. Reattach the spigot and handle onto the faucet, and turn on the water to test the faucet.

Learn More
Sources:

Related Questions

  • Q:

    What are some advantages of hard water?

    A:

    Hard water is beneficial because it can provide much needed calcium and magnesium to humans, according to the Utah State University Extension Office. It has also been shown to have a correlation to a reduced risk of cardiovascular disease. Hard water is less likely to cause expensive corrosion of pipes, and it tends to taste better than soft water.

    Full Answer >
    Filed Under:
  • Q:

    How do you prime a shallow well pump?

    A:

    To prime a shallow well pump, turn off the power and the pump control valve. Remove the priming plug, fill the reservoir with water and replace the plug loosely. Run the pump, and repeat the process until the water flows smoothly. Replace the plug, and turn the control valve back on.

    Full Answer >
    Filed Under:
  • Q:

    How do you open a clogged drain with baking soda?

    A:

    Open a clogged drain with baking soda by adding an equal amount of vinegar to the baking soda inside the drain, and then flushing the drain with boiling water. Depending on the severity of the clog, you may need to repeat this process more than once.

    Full Answer >
    Filed Under:
  • Q:

    Why is there mold in the toilet?

    A:

    According to the New York Times, mold needs two things to grow, water and food, meaning that anything with organic particles can feed the mold. This can include dirt, skin cells, cotton, cardboard, dust, hair, paper, and wood.

    Full Answer >
    Filed Under:

Explore