Q:

What is a good way to unclog a drain?

A:

Unclogging a drain is a process that normally requires using homemade or commercial drain cleaners, but commercial drain cleaners are known for damaging the pipe itself. Depending on the severity of the blockage, you need vinegar, salt and baking soda to make homemade drain cleaner. For harsher blockages, a plunger or auger is needed.

  1. Make a home-made drain cleaner

    Pour 1/2 cup of baking soda down the drain and another 1/2 cup of vinegar. The fusion of these chemicals can create fumes, so it's important to be careful. Allow it to settle for 3 hours and then run water through the drain. As an alternative, you can try adding 1/2 cup of baking soda and 1/2 cup of salt to the drain and leaving it in overnight.

  2. Use a plunger

    Fill the clogged basin with water to cover the head portion of the plunger. Before applying the plunger, you can use petroleum jelly on the suction lips to attain better suction. Exert up and down strokes until the water flushes down. Repeat as many times as necessary.

  3. Use an auger

    A drain-and-trap auger is very effective for unclogging drains. Remove the stopper and feed in the snake. Crank the handle and adjust the thumbscrew as necessary. Keep turning the handle of the auger if you meet resistance in the drain. Continue moving the handle while withdrawing the auger.


Is this answer helpful?

Similar Questions

  • Q:

    What is a natural way to unclog a drain?

    A:

    One of the easiest methods is pouring boiling water down the drain, which can be very effective when it melts the grease that caused the clog. In many cases, drains can be unclogged using natural methods rather than chemical-laden commercial products.

    Full Answer >
    Filed Under:
  • Q:

    What is the pipe-fitting formula for a 45-degree offset?

    A:

    The pipe-fitting formula for a 45-degree offset in plumbing is the length of a diagonal connector, known as the travel, times 0.707. To calculate rolling offset, when a pipe changes direction both vertically and horizontally, it is necessary to find the values for true offset, the setback and the diagonal.

    Full Answer >
    Filed Under:
  • Q:

    What is a pipe spool?

    A:

    Pipe spools are sections of pipe that have been put together with fittings off-site to meet the needs of a construction project, according to the International Journal of Architecture, Engineering and Construction. Pipe spools increase the speed of construction.

    Full Answer >
    Filed Under:
  • Q:

    How do you solder copper pipe?

    A:

    To solder copper pipe, polish the joining surfaces, apply the flux, heat the joint and apply solder. Each joint requires a few minutes to complete, but the time for the overall project depends on its complexity.

    Full Answer >
    Filed Under:

Explore