Q:

How do you install cove molding?

A:

Cove molding can be installed by nearly anyone who has the proper tools to do the job correctly. Cove molding is a concave-profile molding that is usually used at the junction of an interior wall or ceiling. When it is installed on a ceiling, it is referred to as crown molding.

The first step in installing cove molding is measuring to see how much molding is needed. Some people choose to match the molding to the floor or ceiling color or choose a complementary color. Start in one corner and measure the entire distance around. If the room is symmetrical, the total can be found by multiplying the length of the room and the width of the room and doubling it. Several inches should be added to the total to account for waste or mistakes.

With vinyl cove molding, apply adhesive to the back of the molding and press it in place. The corners are folded at right angles before installing to make it easier to apply. Continue around the room until all of the molding has been installed, and make sure your cuts are straight to keep seams hidden.

For crown molding, follow the same process with the exception of corners. In order to cut the corners of cove molding for the ceiling, a miter saw or a miter box should be used to create seams that meet perfectly.


Is this answer helpful?

Similar Questions

  • Q:

    How do you install green sheetrock?

    A:

    Green sheet rock, also known as green board, is installed in areas exposed to moisture. Put the green board in place and fasten it down with hot-dipped galvanized drywall screws and fiberglass mesh tape. Prior to placing ceramic tile over the green board, coat with a fiber cement. Paint green board using a kitchen and bath enamel.

    Full Answer >
    Filed Under:
  • Q:

    How do you install corner molding?

    A:

    Molding adds an enhanced decor to your walls. However, the process of installing molding requires patience. Thankfully, with the correct tools, the installation of corner molding can be successfully achieved. The tools required for installing corner molding include molding pieces, pencil, protractor, circular saw, finish nails, drill, hammer, fine grit sandpaper, coping saw and a plane.

    Full Answer >
    Filed Under:
  • Q:

    How do I install base molding?

    A:

    Install base moldings by nailing them onto the studs in the wall or gluing them onto the wall. Installation requires baseboard moldings, a miter saw, glue or nails, a pencil and a hammer. You may also need a furniture finishing stick to cover any marks left by the nails. For the purposes of this guide, the floor of the room is assumed to be leveled.

    Full Answer >
    Filed Under:
  • Q:

    How do you install brick molding?

    A:

    Install brick molding by cutting it to size, miter cutting the corners and using adhesive and nails to attach it. You need adhesive, caulk, nails, a hammer, paint, a miter saw and brick molding. You can complete the installation of brick molding in one day.

    Full Answer >
    Filed Under:

Explore