A vinyl gable vent is designed to ventilate stale air from the attic during the summer and prevent rain and snow from dripping through. Gable vents reduce heating and cooling costs.Know More
Before installing the gable vent, remove any insulation that may be in the way with a utility knife.
Next, install the vent frame. Use boards to build a 2-by-4 square frame. Place the frame between the studs and the gable ends, and secure it with screws or nails. Factor in a 1 1/8 inch gap around the entire frame. When you are finished constructing the frame, drill 3/8-inch holes into the vent corners. These holes connect to the exterior of the house.
Mark the position of all of the holes with a pencil or piece of chalk on the roof, and connect the marks. This outline represents the vent opening. Saw along this line to cut out the opening.
Once the vent opening has been cut, see how the vent fits. If the vent fits straight, draw an outline for a flange. Use a circular saw to cut through the siding. Place the vent in the opening, and place the flange against the sheathing.
Finally, install flashing material around the vent opening. Flashing helps prevent water from seeping into the attic. Once the flashing is installed, lower the vent into place. Secure the vent with screws.Learn more in Heating & Cooling
Ceiling fans are designed to run in two directions to save on energy costs in the summer and winter by shifting air to different positions in a room. They run clockwise in the winter and counterclockwise in the summer.Full Answer >
Types of attic vents include gable vents, ridge line vents, soffit vents and turbine vents. Some vents, such as turbines, are powered by the wind, while others use attic fans to improve air flow. Solar attic fans, mounted on the roof and powered by the sun, are also available.Full Answer >
Stylish attic vent covers are available from websites that specialize in vent covers, such as the Custom Gable Vents website, and online marketplaces, such as Amazon. Custom Gable Vents offers customizable vents available in different sizes, shapes and colors, as of 2015.Full Answer >
To install an attic fan, cut out a hole for the fan in the roof, install the fan in the hole, install the regulator nearby, and attach the wires as instructed by the manufacturer. Seal nail holes and put shingles as close as possible to the fan to prevent leakage.Full Answer >