Installing a garage door opener is a two-person job that requires removing the old opener, mounting and aligning the new unit and securing the motor. Read all instructions on the new unit before beginning installation.Know More
To install a garage door opener requires a few steps.
Step 1: Remove the old unit
Removing the existing garage door opener requires two people, as one person needs to unplug and disconnect the sensors and bolts at the unit while the other person disconnects the unit from the garage door. Once both sides are disconnected, both people need to slowly lower the assembly. Remove any remaining mounting hardware from the ceiling or door.
Step 2: Mount the bracket
Lay out all pieces for installation, and measure and mark the area to attach the mounting bracket. Use a torpedo level and ensure the mounting bracket is at the center line of the garage door. Drill pilot holes before attaching the mounting bracket.
Step 3: Attach the track
Attach the track front to the bracket, ensuring it is at a 90-degree angle to the garage door.
Step 4: Attach the motor
Attach the motor to the ceiling joists with metal hanging straps, and then attach the opener arm and track at the door.
Step 5: Install the motion sensors
Install the sensors on either side of the door, about 4 to 6 inches above ground level. These prevent the door from closing if an object is in the way.
Once the garage door opener is installed, test it to make sure everything is working properly, and then enjoy the convenience of the new unit.Learn more about Doors, Windows, & Locks
To install an automobile's power window regulator, remove the interior door panel, speaker and window; disconnect the old motor and regulator assembly; and install the new unit. The only tools needed are a screwdriver and a set of Allen wrenches.Full Answer >
To program a clicker garage opener, start by finding the unit's Learn button and make a note of the color. Assign a specific number to the color; Garage Door Info states that red or orange buttons correspond to number 2, purple to number 3 and green to number 4.Full Answer >
To install a door and frame, prepare the wall framing for the casing frame, mount the frame casing, fill the gaps between the frame casing and the wall framing, and attach the door onto the casing. Testing the door by closing and opening it completes this process.Full Answer >
Installing door trim adds a sense of style to your room and isn't complicated as it might first appear. Once you have all the tools to complete the job, installing door trim takes just a few hours. You need the door trim material, a tape measure, a level, hammer, nails, miter saw, wood putty, wood sealer and paint.Full Answer >