To install insulation in a garage ceiling, first choose the type of insulation that will work best in the space. Each insulation type offers different benefits and requires a different procedure for installation.Know More
Insulation types include roll, batting, blown-in and spray foam insulation.
Step 1: Choose the R-value and size
The R-value is determined based on area requirements, and ceilings and attics commonly use R-30 and R-38 batts. Sizes are determined by the distance between the wall studs.
Step 2: Open the packaging
Take care to avoid cutting the facing and cut lengthwise along the side panel.
Step 3: Install the batting
Push the batts into the open areas, taking special care around corners and edges to ensure full coverage. Face the vapor retarder toward the interior space, unless otherwise stated by local building codes.
Step 4: Staple the batts in place
Friction can hold the batts in place, but to staple faced batts, staple the flanges to the inside of the joists. Avoid gaps and ensure that the facing is not stretched too tightly.
Step 5: Cut to fit
Do not compress the insulation to fit into smaller spaces, which changes the insulation's R-value. Instead, cut the unfaced side with a sharp utility knife about an inch longer than necessary. To join multiple batts, ensure both pieces fit snugly together and cover the entire space without gaps.
An insulated garage ceiling increases the energy efficiency of the entire home, and it is worth the time and effort to insulate the space.Learn more about Building Materials
Drywall is installed over a popcorn ceiling by using the joist locations as anchors for screwing the drywall into place. The process is less messy than removing the popcorn texture and requires little more assistance than a drywall lift to hold the pieces in place.Full Answer >
Soundproof a ceiling by adding a layer of drywall. This timing of this project depends on the size of the area that you want to soundproof. You need drywall, screws and a drill with a screwdriver attachment or a power screwdriver.Full Answer >
To install a ceiling-mounted garage heater, install mounting boards, mount and secure the heater, install the flue and vent, attach the wiring, and connect the gas line. The required supplies are boards, nails, sealant, metal flashing, a block and tackle, clamps, a drill, a jig saw, and basic hand tools.Full Answer >
Vermiculite insulation is a shiny, mica-like mineral that expands when heated and is used as a thermal insulator. It is lightweight and has found its way into many different types of products. Until 1990, however, much of the supply of mined vermiculite was contaminated with asbestos.Full Answer >