Installing a perforated drainage system can be a labor-intensive project that includes digging a sloping trench and laying down a landscape fabric in addition to laying the perforated pipes. When installed properly, perforated drainage pipes help channel away water from a building structure and prevent flooding or water from pooling.Know More
The following steps show how to install a perforated drainage pipe system.
Check with the local building code for the required depth of the trench before digging. Select the best area around a structure to dig the trench. The trench must be at least two times wider than the pipe and deeper than the frost line. Bigger projects may require a backhoe to facilitate the digging.
Drive stakes into the trench, using a sledgehammer, spaced four feet apart. Tie a string on the stake where the pipe will start and wrap it around the succeeding stakes, gradually lowering it one-half of an inch for each stake. This will serve as a guide for the grade of the slope.
With the slope grade determined, pack the soil firmly to make a solid base. Use a tamper to pack the soil properly following the slope.
Lay down landscaping fabric on the dirt to prevent dirt from entering and clogging the pipes. Add about two inches of gravel and level it according to the slope.
Lay down the pipe on the gravel and fill over and around it with four to six inches of gravel. Wrap the fabric around the gravel and top it with soil and sod.
There are a few different methods for connecting a dishwasher drain, says About.com. The plumbing section of this website describes the details for connecting a dishwasher to a drain pipe.Full Answer >
A French drain is a sloping trench that is filled with gravel or rock. The drain often contains a perforated pipe wrapped in filter fabric that is used to carry surface and ground water away from a structure. The gravity created by the drain's slope helps to redirect the water.Full Answer >
Installing a door knob can be as simple as removing a few screws to take out the old knob and putting in the new one. However, if the openings for the knob, face plate or strike plate need to be changed, the process is more difficult.Full Answer >
Installing a Formica bathroom vanity can be completed within 2 hours. The job requires a cordless drill, a jig saw, a belt sander, drill bits, adhesive caulk and deck screws. An appropriate hole must be cut before the unit is inserted and secured into place./