Q:

How do you install a water pump pressure switch?

A:

To install a water pump pressure switch, turn off the power and remove the switch, attach the new switch and replace the pressure gauge. Collect all necessary tools before beginning the project.

A faulty water pump pressure switch can cause several problems, including turning on erratically or remaining on. To diagnose the issue, tap the switch with the handle of a screwdriver, and if the pump turns on unexpectedly, the pressure switch needs to be replaced. Ensure the new switch has the same rating as the original switch. To replace the water pump pressure switch:

Step 1: Collect the tools.

This project requires:

  • 4-in-1 screwdriver
  • Adjustable wrench
  • Pipe wrench
  • Pliers
  • Non-contact voltage tester

Step 2: Turn off the power.

Ensure the power to the pump is turned off at the breaker box. Use the non-contact voltage tester to test the power before starting work.

Step 3: Disassemble the switch.

Attach tape to label each wire first, and then pull out the wires and conduit located behind the conduit locking ring.

Step 3: Remove the old switch.

Unscrew and remove both the old switch and the attached nipple. Screw on the new switch and 1/4-inch by 6-inch galvanized nipple.

Step 4: Remove the pressure gauge.

Remove the old pressure gauge and replace with the new unit. Carefully screw on the pressure gauge without over-tightening.

Learn More

Related Questions

  • Q:

    How do you troubleshoot water well problems with the pressure switch?

    A:

    The pressure switch to a well pump may shut down a well or cause the water not to flow, especially if both the switch and a pressure tank are affixed to the system. Both parts can cause an over-circulation of water, which, in turn, shuts down a system. The shut-off measure is a safeguard in case a pipe breaks while water is being pumped from the well.

    Full Answer >
    Filed Under:
  • Q:

    How do you install a light switch?

    A:

    To install a light switch, remove the old switch from the wall, disconnect the wires, and reconnect them to a new switch. Before beginning this process, disconnect the electricity at the electrical panel, and test the switch to make sure it is off.

    Full Answer >
    Filed Under:
  • Q:

    How do you prime a shallow well pump?

    A:

    To prime a shallow well pump, turn off the power and the pump control valve. Remove the priming plug, fill the reservoir with water and replace the plug loosely. Run the pump, and repeat the process until the water flows smoothly. Replace the plug, and turn the control valve back on.

    Full Answer >
    Filed Under:
  • Q:

    How do you adjust a Square D well pressure switch?

    A:

    Adjust a Square D well pressure switch by turning it clockwise to raise the pressure and counter-clockwise to decrease the pressure. Prior to adjusting the switch, follow safety precautions and look for any faults in the switch components. Adjusting the Square D well pressure switch increases the water pressure through the entire house.

    Full Answer >
    Filed Under:

Explore