Q:

How do you mount deer horns on a board?

A:

Quick Answer

Mounting deer antlers onto a board can be completed in just a few minutes with the right tools. In order to mount deer antlers, you will need a drill, a hammer, a skull mount, drywall screws, brass tacks, rope and a glue gun.

Know More

Full Answer

  1. Drill and mount the skull to the skull mount

    Use your drill to create three holes in the skull. These holes should be large enough to be used with drywall screws. Once you create the holes, line them up with your skull mount, and insert the drywall screws. Tighten the screws until the skull is secured to the mount.

  2. Cover the mount and hammer in tacks

    Place the cover that came with your mount on top of the mount so that the antlers are exposed. Using a hammer and some tacks, nail the cover in place on top of the mount. Most covers for skull mounts have holes in their surfaces designed for the insertion of these tacks.

  3. Adorn with rope and glue

    Wrap the rope around the antlers in a style that you like, and use the glue gun to place little dots at the contact points. Press the rope firmly until it dries in place.

Learn more about Carpentry

Related Questions

  • Q:

    How do you drill through a marble board?

    A:

    Drilling a hole into marble requires using the correct tools, measuring carefully, marking the spot and working slowly. Marble is very hard and brittle and may easily chip or crack.

    Full Answer >
    Filed Under:
  • Q:

    How do you install a Hardie board for a floor tile?

    A:

    To install Hardie board for floor tiles, secure the plywood subfloor to the floor joists, sand down any ridges, sink screws and nails into the subfloor, precut the cement board to fit the floor, apply thin-set mortar to the subfloor, and then install the boards. Cover the seams with tape and thin-set mortar.

    Full Answer >
    Filed Under:
  • Q:

    How do you clean white Sidi boots?

    A:

    Cleaning white SiDi boots can be completed in a few minutes, though the boots need some time to dry. In order to clean your white SiDi boots, you need a soft brush, a sponge, liquid soap, newspaper and silicone lubricant.

    Full Answer >
    Filed Under:
  • Q:

    How do you make a mouse glue board?

    A:

    Making a mouse glue board is a relatively simple process that can be completed in a few minutes with the proper materials. In order to make your own mouse glue board, you will need a shoebox, some glue, scissors, liquid soap and a knife.

    Full Answer >
    Filed Under:

Explore