Q:

How do I move a light switch?

A:

Quick Answer

To move a light switch, disconnect the power, remove the cover plate, unscrew the switch from the electrical box, detach the terminal wires from the switch, cut an opening in the wall, insert a new electrical box, and reinstall the switch. Reconnect the power, and test the switch.

Know More

Full Answer

  1. Uninstall the switch

    Switch off the circuit breaker that supplies power to the switch, unscrew and remove the cover plate from the switch box, undo the screws that attach the switch to the electrical box, then pull the switch from the box. Note how the switch is wired, loosen the screws that secure the wires to the terminals, and pull out the wires from the switch.

  2. Cut the electrical box opening

    Point the screwdriver to the knockout tab, and hit the screwdriver with a hammer to remove the tab from the electrical box. Run the screwdriver through the hole left by the tab, hold the screw against the wall, and hit it again with a hammer to mark the opening in the wall. Place the new electrical box against the mark, draw around the box edges with a pencil, and then cut and remove the mass inside the rectangle.

  3. Reinstall the switch

    Place the new electrical box in the cut hole, and secure the box to the wall stud with nails. Screw each wire to its respective terminal, attach the switch onto the box, replace the switch cover, and then switch on the breaker to test the switch.

Learn more about Electrical
Sources:

Related Questions

  • Q:

    How do you wire a basic light switch?

    A:

    To wire a basic light switch, turn off the power to the switch at the breaker, pull the wires to the switch out of the wall, connect the wires to the screws on the sides of the switch, and screw them down with a slotted screwdriver. Finally, test the switch.

    Full Answer >
    Filed Under:
  • Q:

    How do you wire an electrical outlet to a wall switch?

    A:

    To wire an electrical outlet to a wall switch, turn off the power, install the new switch box, run a new cable from the switch to the outlet, disconnect the tab connecting the receptacles on the outlet and connect the wires to the appropriate terminals. Follow all local building codes and consult a licensed electrician with questions.

    Full Answer >
    Filed Under:
  • Q:

    How do you repair a table lamp switch?

    A:

    To repair a table lamp switch, replace the bulb, tighten or reattach any loosely attached or broken terminal wires inside the socket respectively if the new bulb fails to light, and then replace the socket if the bulb still fails. This procedure, however, varies with the lamp type and make.

    Full Answer >
    Filed Under:
  • Q:

    How do you add and wire a 110-volt electrical outlet?

    A:

    To add and wire a 110-volt electrical outlet, turn off the power, cut the hole for the new electrical box, pull out the electrical cable and attach the wires to the outlet. Consult an electrician to wire the new outlet to the circuit breaker.

    Full Answer >
    Filed Under:

Explore