To use a washing machine, divide clothing by color and material, then select a temperature and wash cycle appropriate for the clothing category. Pour in an appropriate amount of laundry detergent, and load clothing. Close the lid of the machine, and activate it.Know More
Different types of clothing require different washing conditions. Divide the clothing into light colors, dark colors, whites and delicates. When you are uncertain, use the predominant features of the item to make the decision. Dark clothing can ruin the coloration of light clothing. White clothing can be cleaned at a higher temperature on a rougher cycle, while delicate clothing requires a lower temperature and a gentler cycle to avoid ruining it. Denim clothing and linens can be cleaned in similar conditions to white clothing.
Measure out the amount of detergent recommended for the coloration, dirtiness and amount of clothing you are washing. Pour this into the detergent holder. For very dirty clothing, add detergent to the prewash section as well. When cleaning whites, you can substitute or add chlorine bleach. Be careful to avoid bleaching denim, if you choose to wash it with your whites instead of separately.
Loosely load the clothing into the washer. The clothing should have space to move from side to side as well as top to bottom.
Find the dial connected to the wash and rinse cycles. Use warm for darks and lights. Hot should be used for whites, denims and linens. Cold should be used for delicates. If there are numerical inputs, use below 68 degrees Fahrenheit as cold water, 86 to 122 degrees for warm and 140 to 194 degrees for hot. There is also an agitation dial. Select normal for lights and darks, whites for white clothing, denim and linens and delicates for delicate clothing. You can also use permanent press for clothing that cannot be ironed.
Once you have selected the temperature and agitation, activate the washer. For some machines, there is a separate button. For others, the agitation selection dial must be pushed in to select agitation and pulled out to start the machine.
To plumb in a washing machine, you need to connect the drain and level the machine. If you choose a new location, you might also need to get an electrical outlet.Full Answer >
The most common reason for a washing machine to smell like mold is the build up of mold or mildew underneath the rubber gaskets in the machine. This occurs when the rubber gaskets are worn down to the point where moisture leaks behind the gaskets and becomes stagnant. This issue can be easily remedied by replacing the rubber gaskets.Full Answer >
Water quality and residue from laundry detergents and softeners can cause stains on clothes inside the washing machine. Rust-colored stains, for instance, may be caused by iron in the local water supply.Full Answer >
A washing machine may stop spinning because of malfunctioning direct drive motor coupling or a bad door lock. A defective lid switch may also cause a washer to stop spinning.Full Answer >