A Remington electric pole saw is composed of a trigger switch, latch lever, hand guard, chain, bar, oil cap, bracket kit, sprocket kit, E-ring, adjustment plate, sprocket cover, a sprocket and a pole extension. The chain of the pole saw may be one of two different designs.Know More
The more common design, called a full compliment chain, has one small blade situated at two link intervals along the chain. A full skip chain has one blade for three links. Blades on the pole saw chain are composed of a "tooth" and a "raker." The raker is positioned in front of the tooth of the blade and regulates the depth at which the chain cuts. If the raker is too small, the pole saw may kick back and cause injury.
Kickback occurs when the bar, which holds the chain, comes in contact with the object that is being cut. This causes the pole saw to lurch up and away from the object. However, if the raker is too large, the pole saw does not cut effectively. The sprocket of the pole saw is the driving force behind the chain. It is turned by a small motor located in the head of the pole saw.Learn more about Tools
A good wet-tile saw for cutting ceramic and porcelain tile combines power, cutting speed and size capacity with cutting quality, accuracy and portability. Contractors Direct tested a selection of seven models from six manufacturers, determining that the DeWalt D24000S best fits these criteria.Full Answer >
Use a power miter saw by keeping it steady and holding it firm. Make sure you adjust the angle for cleaner cuts as well as practice safety techniques. Manual miter saws may require a different set of techniques.Full Answer >
A double-bevel miter saw creates angled cuts on either the left or the right side of a material, allowing for cuts in both directions without the need to rearrange the material. For comparison, a single-bevel saw cuts in only one direction, which requires you to flip the material over to cut in the other direction.Full Answer >
In order to use a circular saw, the wood should first be placed on a suitable surface and marked where it is to be cut. After the proper safety precautions are taken, the saw should be lined up with the mark and the trigger pulled to start the cutting motion.Full Answer >