Q:

How do you perform an oil change on a Craftsman lawn mower?

A:

Quick Answer

To perform an oil change on a Craftsman lawn mower, run the mower for a few minutes, and drain the warm oil by inverting the mower or opening the drain plug. Add 10 ounces of the correct type of oil, and check the dipstick, adding additional oil as needed.

Know More

Full Answer

  1. Make initial preparations

    Warm up the oil by running the lawn mower for two minutes, and then allow the engine to cool off for an additional minute. Wear protective gloves to guard against cuts from small engine parts. Detach the spark plug wire from the spark plug for easier access and to ensure the mower cannot accidentally start.

  2. Remove the old oil

    Riding lawn mowers often have a drain plug. Open this plug after you attach a drain sleeve. Push mowers may not have a plug and need to be inverted in order to drain the oil through the open oil cap. Tip the lawn mower over in the direction opposite to the air filter in order to avoid oil spillage onto the filter. Use a funnel to direct the used oil into a container.

  3. Add clean oil

    With the drain plug closed and the mower in the upright position, add the clean oil. Many mowers use 4-cycle small engine oil, but check the manufacturer's guide first for its recommendations. Add 10 ounces of oil, and check the fill level using the dipstick. Continue adding oil until the dipstick registers full.

Learn more about Tools
Sources:

Related Questions

  • Q:

    How do you fix a flooded lawn mower?

    A:

    In order to fix a flooded lawn mower, the gas filter needs to be dried. This can be done by waiting for it to dry or by manually drying it. Other fixes include adjusting the float in the gas bowl and adjusting the choke.

    Full Answer >
    Filed Under:
  • Q:

    What is a Murray lawn mower diagram?

    A:

    A Murray lawn mower diagram is a printed representation of the various components of a Murray lawn mower. The purpose of the diagram is to help people who wish to repair these mowers. The diagram tells the user exactly where each part on the mower belongs.

    Full Answer >
    Filed Under:
  • Q:

    How do you sharpen lawn mower blades?

    A:

    Sharpen a mower blade by disconnecting the spark plug wire, removing the blade, filing the cutting edge, checking for balance and reinstalling the blade. The process can be completed in less than 30 minutes.

    Full Answer >
    Filed Under:
  • Q:

    How do you repair a lawn mower engine?

    A:

    Lawn mower problems are commonly associated with loose, disconnected or dirty spark plugs, and to solve the problem, you must remove the spark plug and replace it with a new one. This can be done in minutes at a low cost.

    Full Answer >
    Filed Under:

Explore