Q:

How is a playground slide built?

A:

Quick Answer

Building a playground slide is a moderately easy project that involves installing support posts, a platform deck and the slide. To complete the project, use a tape measure, post hole digger, circular saw, sawhorse and a level.

Know More

Full Answer

To build a playground slide, begin by deciding where the slide is to be permanently installed, making certain local codes allow building at the proposed location.

  1. Install support posts
  2. Footings for the support posts should be 2 feet deep. Pack 6 inches of gravel in the bottom of the hole for drainage, and install the support post, making sure it is level and plumb. Posts should be weather-treated and the hole should be three times the diameter of the post. Pour dry, fast-setting cement into the hole, leaving about 4 inches at the top. Pour in water and allow it to soak into the cement. Repeat for all four corners.

  3. Install the deck
  4. With the angle of the slide in mind, fasten 2x6 floor joists around the outside of the set posts. Fasten with lag bolts or galvanized fasteners. Butt the joist together for 90-degree corners. Inside the framed joists, run the center joist perpendicular to the direction of the decking.

  5. Install the slide
  6. Install the slide from the deck to the landing.

Learn more about Outdoor
Sources:

Related Questions

  • Q:

    How do you build a fence on a slope?

    A:

    A fence may be built along a slope either by following the contour of the slope or by using stepped fencing. As its name implies, stepped fencing gradually follows the gradient of the slope with stepped sections leaving gaps underneath the fence. The contour or racked fencing, on the other hand, follows the undulations of the slope and are installed uniformly close to the ground.

    Full Answer >
    Filed Under:
  • Q:

    How is Math Playground rated?

    A:

    Most ratings of Math Playground are in the range of three to four out of five. It receives higher ratings for educational value, while website organization and support features get the lowest scores, commonly falling in the range of two to three out of five.

    Full Answer >
    Filed Under:
  • Q:

    How do you make donkey ears?

    A:

    Donkey ears are a quick and easy project to complete. Children can make them with minimal supervision. To make these paper donkey ears on a headband, you need brown and pink construction paper, scissors, white glue and clear tape.

    Full Answer >
    Filed Under:
  • Q:

    How do you build a hot tub deck frame?

    A:

    In order to build a hot tub deck frame, clear the area for the deck, install concrete footers for the whole deck, as well as the area directly below the hot tub, build two frames and install the joists and support posts. The deck requires two frames because of the weight of the hot tub.

    Full Answer >
    Filed Under:

Explore