To refinish a wood-stained fiberglass entry door, remove the door, strip the old finish, and replace it with a new stain, sealed with clear spar lacquer. Refinishing can take over 24 hours to complete.Know More
Remove the door from the entryway by unscrewing it from the hinges holding it in place. Set aside the screws for reuse. Place the door onto a pair of padded sawhorses with the exterior of the door facing upward. Remove all of the door attachments, such as the door knocker and doorknob. Place a drop cloth beneath the sawhorses if working indoors.
Mask off areas of the door that are not to be refinished with painter's tape. Apply a stripping agent suitable for use on fiberglass onto the door. Allow the agent to sit, per the manufacturer's recommendations. Use steel or copper wool to strip the finish or paint; scrubbing in a circular motion to prevent scratches. Switch to a stiff bristle brush to access recessed areas. Sand the door with increasingly finer grades of sandpaper to remove the stain from the fiberglass, and then wipe the door clean with a wet cloth.
Using a clean, dry cloth, blot the door with the stain to apply the new color. Distribute the stain evenly to achieve a smooth, consistent finish, wiping in the direction of the grain. Remove any excess stain with the cloth. Allow the door to dry for 24-hours to properly absorb the stain.
Brush three layers of clear spar lacquer over the newly stained door to protect it from the elements. Allow each layer to dry completely before applying another coat of lacquer. Once dry, reattach the door hardware and hinges, and reinstall the door in the entryway. Remove the painter's tape.
Exterior fiberglass doors that are constantly exposed to the weather often have a cracked or flaked top coat finish. To improve the appearance of your fiberglass doors, DoItYourself recommends applying a new topcoat finish. Prepare painter's tape, cloths, plastic sheets, paintbrushes, primer, stain and clear topcoat.Full Answer >
Installing door trim adds a sense of style to your room and isn't complicated as it might first appear. Once you have all the tools to complete the job, installing door trim takes just a few hours. You need the door trim material, a tape measure, a level, hammer, nails, miter saw, wood putty, wood sealer and paint.Full Answer >
To measure the size of a door, simply measure the height of the door and then measure the width of the door. All you need is measuring tape. Standard exterior door measurements are 36 inches x 80 inches. Standard interior door measurements are 32 inches x 80 inches.Full Answer >
A door rebate is an alternate British term for a rabbet, a deep groove or notch cut into the edge of building material such as wood. The groove allows a tight fit with other objects that are placed against or into the material.Full Answer >