Remove the agitator from a GE washer by first removing the agitator cap and fabric-softener dispenser. Use a socket wrench with an extension to remove the agitator bolt, and then carefully lift out the agitator.Know More
You need a socket wrench, a 10-inch socket extension, a 7/16-inch socket and a flat-head screwdriver to remove the agitator from a GE washer.
Ensure that the washing machine is unplugged from the wall to safely remove the agitator. Lift the lid to access agitator.
Pull out the fabric-softener dispenser located on the top of the agitator. Hold the small ring along the bottom of the dispenser, and lift up to remove the dispenser.
Remove the agitator cap by inserting a flat-head screwdriver along the edge of the agitator and agitator cap. Pop the cap from the top of the agitator by twisting the screwdriver. Skip this step for washers without an agitator cap.
Connect a 10-inch socket extension to a socket wrench, and then attach a 7/16-inch socket to the extension.
Remove the agitator bolt by inserting the socket into the agitator from the inside. Turn the wrench counter-clockwise to loosen the bolt. Reach your fingers beneath the agitator, and lift it out carefully to remove it.
To change the belt on a General Electric Space Maker Washer and Dryer, disconnect the unit?s power cable from the electrical outlet. Remove the screws from the rear of the appliance, and remove the back panel. Move the idler arm to the side and pull the belt from the dryer drum; this detaches the belt from the motor pulley. Install the new belt, and reassemble.Full Answer >
Unusual odors caused by mold and mildew, leaking gaskets, and improper filling or draining are some of the most common problems with GE front-loading washers. Some issues can be remedied at home, while others may require additional parts for repair.Full Answer >
To replace the door seal, it is necessary to remove the top and front panels on most front-load washing machines. Any wiring, such as the door switch, must be disconnected to remove the panels. The boot seal can be installed in about an hour using basic tools such as a screwdriver.Full Answer >
Removing the top of a GE washing machine requires using a putty knife or flat blunt object to release the spring catch. It may be necessary to lift the console at the back of the machine in order to remove the lid.Full Answer >