Tire marks can generally be removed from a concrete driveway by cleaning the area with a degreaser. If the marks are embedded deeply into the sealant on the driveway, then a solvent is used to loosen the sealant, allowing it to be cleaned. Stripping the sealant is also an option.Know More
Tire markings are caused by hot tires running over the sealant applied onto the concrete driveway. The sealant contains plastizers, which are added to the tires to make them flexible. As the tires are used, the plastizers heat up, which allows them to leech from the tires. When the leeching plastizer comes into contact with certain sealants used on concrete driveways, they migrate, discoloring the sealant and causing the tire marks. The higher the quality of the tire, the more plastizer tends to be present in the tire formula, making them more likely to cause marking.
To prevent the tire marks from appearing, car owners can switch to harder, lower-costing tires. Driveways can also be covered with denser sealants that are more resistant to marking. These denser sealants are those with greater cross-linking in the resins used. Sealants that are most resistant are the higher-solids acrylics, epoxy sealers or cross-linked polyurethanes.Learn more about Outdoor
According to AcmeHowTo.com, antifreeze can be removed from a concrete driveway by covering the stain in water, sprinkling powdered laundry detergent on it, covering it in newspaper, wetting said newspaper and letting it all sit for at least three hours. After time is up, a wet nylon bristle brush can be used to scrub the area and ensure that it is completely clean.Full Answer >
A concrete driveway takes 24 to 48 hours to dry. Walking on the driveway without damaging the concrete is possible after this time. Even though concrete is solid after two days, there are still time limits on what the driveway can handle.Full Answer >
The cure time for a concrete driveway is about 28 days under optimal warm-weather conditions. This length of time should cure the concrete sufficiently to a hardness of 4,000 psi, though suboptimal weather conditions prevent this.Full Answer >
Before building a gravel driveway, strip the soil down in the area where you wish to lay the driveway, lay down a sub-base and install wooden frames. You need a hoe, a shovel, a wheelbarrow or large bucket, rolls of geotextile fabric, an asphalt squeegee and wooden boards.Full Answer >