To replace a shower head, turn off the water, remove the old shower head, and install the new shower head after cleaning the pipe and applying thread seal tape. Performing this task requires a new shower head, a few soft rags, paper towels, a wrench, thread seal tape and a sturdy stool. The process takes around 15 minutes. Before starting, read all instructions included with the shower head, and make sure that the shower head is fully assembled.Know More
Turn off the water faucets connected to the shower head. There is no need to turn off the water supply throughout the entire home.
Loosen the shower head by turning it with a wrench in a counter-clockwise position. Place a soft rag under the mouth of the wrench to avoid damaging the finish on the shower head or the connecting pipe.
Clean the pipe where the shower head attaches with a damp paper towel. Make sure to clean the threads thoroughly to ensure the new head goes on smoothly. Dry the pipe completely.
Wrap the threads on the pipe with thread seal tape by winding the tape around the thread area in a clockwise motion. Add two layers of tape to ensure a tight seal that is much less likely to leak.
Attach the new shower head to the pipe by screwing it in a clockwise motion over the thread seal tape.
Turn on the water to the shower, and watch for leaks around the shower head. If there are leaks, tighten the shower head slowly with a wrench until the leaking stops.
A flouride shower filter is an attachment to a shower head that filters out and neutralizes fluoride and other chemicals commonly found in tap water. Many people are concerned about adverse side effects of bathing in fluoride.Full Answer >
To install a shower head, remove the old one, wrap Teflon tape around the threads of the shower stem, attach a diverter to the stem, and screw the shower head onto one end of the diverter. Wrap the diverter's other end with Teflon tape, and secure the hose attachment.Full Answer >
Replacing a shower arm takes just a few minutes and it requires the user to unscrew the existing one. The tools needed includes thread seal tape and plumbers' putty.Full Answer >
To replace a shower valve, remove the valve trim, then remove the old valve. Install the new valve by cleaning the pipes, removing the plastic cartridge from the valve, applying flux and inserting the pipes. Use a torch to solder the connections.Full Answer >