Q:

What is a safe distance when working around power lines?

A:

Quick Answer

The minimum distance when working on construction around power lines depends on the voltage of the power lines. The standard recommended distance is a 20-foot radius around the line, but the distance can range from 10 to over 45 feet depending on the voltage.

Know More

Full Answer

The level of risk to workers determines the minimum distance from power lines. Low-voltage lines (up to 50 volts) require a 10-foot clearance, increasing to a 45-foot clearance for high-voltage (1,000 volts or more) lines. If any equipment on the work site could come within the clearance zone of a power line, the owner of the construction company must either de-energize the power line or take measures to ensure workers do not get too close. These measures range from erecting physical barriers to using another employee as a "spotter" to tell machinery operators when to stop.

Learn more about Electrical
Sources:

Related Questions

  • Q:

    What are signs of a bad voltage regulator?

    A:

    Warning lights, unpredictable engine performance and dimming or pulsating lights are all signs of a faulty voltage regulator. A number of symptoms can develop if the voltage regulator fails to deliver sufficient voltage. Warning lights may not inform the operator of such a failure until it is too late, so it is important to be aware of the associated issues.

    Full Answer >
    Filed Under:
  • Q:

    What is the mains voltage in the United States?

    A:

    The standard mains voltage used in the United States is approximately 110 to 120 volts, according to Georgia State University's physics department. Depending on the power load, it can vary between these two measurements.

    Full Answer >
    Filed Under:
  • Q:

    How do you use a voltage tester?

    A:

    To use a voltage tester, place both probes of the tester on each wire or connection point. The light on the housing of the tester glows if the component that is being tested is receiving electricity. The light does not glow if there is no electricity flowing into the component.

    Full Answer >
    Filed Under:
  • Q:

    What is the electrical voltage in Mexico?

    A:

    The electrical voltage in Mexico is 110-120 volts, the same as in the United States. While the sockets are the standard two prong versions that are found in the United States and Canada, adapters may be required for certain equipment.

    Full Answer >
    Filed Under:

Explore