The first step in repairing a leaking garbage disposal is to find out the exact location of the leak. There are four places that the garbage disposal unit may be leaking from. It is important to determine if in fact the garbage disposal is leaking from the unit itself or rather if one of these other pipe intersection points is causing the leakage.Know More
It the water is leaking where the garbage disposal connects with the sink and the leak is running down the disposal unit, then the connection between the sink drain and the disposal unit must be resealed. This can be done using standard plumber's putty found at a local hardware store. Unplug the disposal unit and loosen the connector ring located around the top of the unit just below the drain. Once this ring has been loosened, pull the disposal unit down to remove it from below the sink. The metal ring that sits in the drain on top of the sink tub can now be removed. Apply the plumber's putty to bottom of the ring and put it back into place to repair the seal. Reattach the disposal unit and check for leakage.
If there is still water leaking, make sure that the points where the dishwasher and the unit's drainpipe connect are sealed tightly. Finally, if water is leaking from the base of the unit itself, and all other seals have been checked, then the unit needs to be professionally repaired.Learn More
To install a garbage disposal, add the assembly, install the mounting ring, attach the power cord, add the disposal unit, connect the supply lines, and lock the disposal in place. You need plumber's putty, a wrench and a screwdriver to complete this project.Full Answer >
When dealing with a broken garbage disposal, there are many problems that might cause an issue. The most common problem is a clogged flywheel. To repair this problem, you need the offset wrench that came with the disposal.Full Answer >
To unclog a drain with a disposal unit, Family Handyman recommends first using a plunger to loosen the clog and force the material down the drain. Another way to clear a clog is to disconnect the drain trap connected to the disposal and clean it out. If that doesn't work, Bob Formisano of About Home Repair explains an auger can clean out a clog beyond the drain trap.Full Answer >
Repair a blocked garbage disposal by removing large items located inside the unit, twisting the hex hole located on the bottom of the disposal, or cleaning the waste pipe that is connected to the unit. Most blockages can be eliminated in less than an hour.Full Answer >