To troubleshoot gas furnace burners that do not ignite, inspect the pilot light, ensure the gas valve is on and perform other common troubleshooting tasks. Review the owner's manual for model-specific troubleshooting instructions.Know More
Follow these steps below to troubleshoot furnace ignition problems:
Older furnaces have pilot lights, which can become loosened or clogged. To unclog a pilot orifice, first turn off the gas and power to the furnace, and then use a thin wire to unclog the debris within the orifice. Ensure the pilot light's flame adjustment screw is turned high enough for the flame to not have any yellow in it.
Refer to the owner's manual for specific instructions on how to relight a pilot light, or consult a professional.
On furnaces that feature an electronic ignition, turn the power off and then on again to reset the module.
The furnace needs to receive gas to operate, so inspect the gas valve to ensure it is still in the "On" position. If there are other gas appliances in the home, turn them on to make sure gas is still being supplied to the home.
If common troubleshooting tasks fail, consult a professional to inspect the furnace and perform maintenance and repairs.
If a gas wall heater is not operating correctly, some things to check are the thermostat, the breaker box, the pilot light and the gas valve. If the odor of gas is detected, however, one should call a professional to diagnose the problem.Full Answer >
By checking the furnace's power supply, thermostat, filters, pilot and gas valve, a homeowner can determine why a furnace motor blower is not turning on or functioning properly according to popular contractor Bob Villa. Either the blower needs servicing or another component of the furnace could be causing it to malfunction.Full Answer >
A gas furnace flame sensor is part of an electric ignition system that is connected to the gas valve to control the flow of gas to the furnace. A flame sensor can come in both L or straight shapes, and it is part of the furnace burner's basic assembly.Full Answer >
A gas furnace that does not start sometimes requires relighting the pilot light. After waiting a few minutes for fumes to clear the area, the owner can turn the dial to pilot, press the red button, and light the pilot. Holding the button down for 30 seconds warms the thermocouple.Full Answer >