Although there are many reasons a Roper electric dryer does not work, troubleshooting should begin with the simplest: making sure it is getting power. If the dryer is not getting power to the terminal block, it does not work. A volt meter offers a quick and easy way to ensure power is available. Other reasons a dryer might not work include overheating and a clogged exhaust vent.
The power block is where the leads from the power cord attach to the appliance. A volt meter should provide a reading of 120 volts between either side terminal and the center terminal. When the leads are touched to the two side terminals, the meter should read 240 volts. If there is no power, potential sources of the problem are the circuit breaker, the circuit, the power plug or the power cord.
Dryers have a thermal over-limit switch at the exhaust. It the machine overheats, this fuse-like switch stops the machine from heating. It requires replacement before the clothes will dry again.
A clogged exhaust vent prevents moisture from escaping the appliance and leaves clothes wet at the end of the cycle. In addition to preventing the machine from working correctly, a clogged exhaust vent creates a fire hazard.
Whirlpool makes Roper appliances, and troubleshooting guides tend to follow the manufacturer name brand, according to Appliance-Repair-It.com. These same guides apply to Crosley, Estate, Maytag (after 2006) and most Kenmore dryers.Learn More
Gas dryers stop heating for several reasons. Use these steps to troubleshoot your dryer and identify the root of the problem. The required supplies are an ohmmeter, a handheld vacuum and a small flashlight. A screwdriver is also helpful for many dryer models.Full Answer >
To troubleshoot a Whirlpool gas dryer, identify the type of problem the unit is experiencing. If there is very little heat, then there can be a problem with airflow. However, if the dryer is not heating at all, the problem is likely due to a faulty electrical part. To troubleshoot, start by testing the dryer's igniter, flame sensor and valve.Full Answer >
To troubleshoot a dryer, it is necessary to identify the problem and determine which possible solution is the cause of the problem. Parts, such as dryer belts, may be necessary to repair the dryer. Most problems can be solved within a few hours if the necessary parts are readily available.Full Answer >
If your Speed Queen dryer does not start or heat, it may be possible to troubleshoot it rather than calling a repairman. Troubleshooting is also possible if the clothes come out wrinkled or inadequately dried.Full Answer >