After identifying the symptoms, troubleshoot a Whirlpool dryer by looking first for the most common problems, moving down to less frequent problems until you find the issue. Common complaints include noisiness, poor drying, insufficient heat and too much heat. Possible solutions include identifying blockages, broken components and malfunctioning control systems.
Abnormal noises emanating from a Whirlpool dryer can be caused by a broken or damaged belt, broken tensioner springs, objects stuck in the dryer vanes and objects stuck in the blower wheel. For Whirlpool dryers, look first for items caught in the removable plastic dryer vanes.
If the dryer is not drying items thoroughly, check for poor airflow by looking for clogs in the dryer vents. Ensure that the belt is not broken by checking that the dryer is turning as expected. Next, check if the motor is locked.
Depending on your model, address problems of insufficient heat by checking the air flow, thermostat, temperature control system, gas burner and electric heating elements.
If the dryer's temperature is too high, look for thermostat problems, poor or obstructed airflow, clogged dryer vents or blocked exhaust.
When dealing with a broken garbage disposal, there are many problems that might cause an issue. The most common problem is a clogged flywheel. To repair this problem, you need the offset wrench that came with the disposal.Full Answer >
Repairing a whirlpool ice maker begins with checking the functionality of the shutoff arm. Check if water passes through the water valve to see if it needs replacement. Set the temperature slightly higher in case of frozen hose ends, and check for signs of broken parts and gears.Full Answer >
If the soap dispenser is not working, simplehuman suggests making sure that the unit is turned on, that the batteries are fully charged and that the sensor window is clean. These simple steps correct most problems.Full Answer >
Troubleshooting a Rheem furnace that will not light consists of checking the spill switch, the HSI heater and the ignition control. Checking these items requires an ohmmeter, a voltmeter and a screwdriver. Completion of the project takes approximately a day.Full Answer >