Q:

How do you unblock a dishwasher?

A:

Quick Answer

The first step to fix a blocked dishwasher is to make sure it finished its last cycle. Dishwashers don't drain completely until the cycle is complete, according to DoItYourself. The appliance tends to retain some water if something, such as a power failure, interrupts the cycle.

Know More
How do you unblock a dishwasher?
Credit: Donald Iain Smith Getty Images

Full Answer

Check the fuse or circuit breaker that protects the dishwasher, and reset the breaker if necessary. Additionally, inspect the dishwasher door, and check to see if it has caused a malfunction. If the appliance is still blocked after performing these steps, the next solution is to clean the dishwasher, as large pieces of food may block its drain. Wear gloves, and remove any food from the bottom of the machine. The next time you put plates in the dishwasher, be sure to remove all leftover food to prevent blockage.

Examine the hoses running from the dishwasher to ensure they are still attached properly. Read the dishwasher manual to find out where the hoses are located and how to fix loose hoses. Check the hoses running from the dishwasher to the sink, and use a pipe snake or auger to remove blockages. Wire cut from a clothes hanger may also be used to unclog the pipes.

Sources:

  1. doityourself.com

Is this answer helpful?

Similar Questions

  • Q:

    How do you unblock a toilet?

    A:

    A simple way to unclog a toilet is to use a plunger, but in the event that there isn't a plunger available, it is possible to unclog a toilet with household items.

    Full Answer >
    Filed Under:
  • Q:

    How do you keep constant pressure in a well pump?

    A:

    The first step in solving well pump water pressure problems is to inspect the pump pressure switch. Turn off the pump. Locate the large center spring counter on the pump, and turn it clockwise following the manufacturer's instructions for adjusting water pressure. Turning it clockwise increases water pressure. If the water pressure is found to be adequate, inspect the pump for bugs, dirt, loose or broken seals or wires.

    Full Answer >
    Filed Under:
  • Q:

    How do I repair a leaking bathroom faucet?

    A:

    The first step in fixing a leaking bathroom faucet is to shut off the water supply and close the sink drain. Tape the jaws of the wrench to avoid putting scratches on the fixture. Remove mineral deposits on the faucet parts by using vinegar oil. The necessary tools needed for this task include a flat-head screwdriver, an adjustable wrench, replacement O-rings, washers and penetrating oil, such as CRC.

    Full Answer >
    Filed Under:
  • Q:

    How do you make a shower basin?

    A:

    To make a shower basin, cover cement blocks with a waterproof liner, seal the drain with masking tape, pour concrete over the liner, install tiles on top, and brush on two coats of clear sealant. This four-day procedure requires cement blocks, a knife, a shower liner, concrete, a trowel, grout, sealant, a screwdriver, screws, a paint brush and masking tape.

    Full Answer >
    Filed Under:

Explore