Q:

How do I unclog a washer drain?

A:

The first step is loosening the cylinder with a pair of pliers to look at the hose or pipe. Shine the inside of the pipe with a light to find the clog and pour hot water to loosen the blockage. Remove the clog from the pipe and connect the hose to a water source to rinse out any debris. Reattach the hose as before.

The cylinder is typically located towards the back of the machine. Depending on the washer, there may be a few hoses, so choosing the correct one is essential. Turn counterclockwise to loosen the cylinder. A straight coat hanger should be long enough to reach the clog after pouring with hot water. When unclogging, keep wiggling until the blockage is loosened. When connecting the hose to a water source, the water should flow with ease if the blockage has been removed. If water is still being pushed out then the disruption remains. Keep trying to unclog the blockage and test as necessary. If using a chemical to clean the pipe, be sure to wait ten minutes before flushing out. Once the blockage has been removed, reattach the hose to the cylinder and turn clockwise. If there is still a problem, it could mean a sewer clog, in which case a professional needs to be contacted.

Sources:

  1. doityourself.com

Is this answer helpful?

Similar Questions

  • Q:

    How do you drain a clothes washer?

    A:

    Draining a washer requires a manual approach by using a bucket or drain hose. The source of the standing water in a washer could be traced to a clogged pump, which requires going in and fishing out the blockage. You need a bucket, sponges and a screwdriver.

    Full Answer >
    Filed Under:
  • Q:

    What are washer lint filters?

    A:

    Washer lint filters capture lint produced during the spin cycle before it can be flushed down the drain. Lint can clog drain lines and cause water to back up in the drain. The production of some lint is a normal part of the wash cycle.

    Full Answer >
    Filed Under:
  • Q:

    How do you drain a Maytag Neptune washer?

    A:

    A Maytag Neptune washer that does not drain properly may have a faulty water pump or an obstruction blocking the pump, explains Mary Marlowe Leverette on About.com. If the pump has no obstruction, it may need replacing. The standing water may be removed by unclamping the drain hose and directing the water into a container.

    Full Answer >
    Filed Under:
  • Q:

    How do you fit a tumble dryer vent?

    A:

    The fitting of a tumble dryer vent starts by ensuring that the water supplies are turned off at the mains and that all water remaining in the piping is allowed to drain away. This is accomplished by running a tap until no more water comes out of the pipe. After this comes fitting the back end of the vent into the tumble dryer.

    Full Answer >
    Filed Under:

Explore