Q:

How do you wire a pull chain switch?

A:

Quick Answer

To replace a pull chain switch, first turn off the circuit break to the pull chain fixture that is currently connected. Next, connect the white wires of the pull switch and replacement wiring and repeat this step with the black wires. Attach the ground wire to the metal mounting plate of the pull switch then mount the pull chain switch into the electrical box in the replacement wiring.

Know More

Full Answer

Pull chain switches are commonly integrated into ceiling light fixtures. In this way, no wall switch connected to the light is needed in order to turn the ceiling light off and on. Pulling too hard on the cord can snap the chain or completely pull it out of the fixture, or the internal switch mechanism can wear out. With some models the cord can be reattached, but with other models the entire switch needs to be replaced if the pull chain that operates the ceiling fan or light is accidentally pulled out.

Pull chain fixtures are made from either porcelain or plastic, but porcelain is recommended because it lasts longer and withstands heat better. When mounting porcelain pull chain fixtures, remember that tightening the screws too tight may crack the porcelain shroud.

Learn more about Electrical

Related Questions

  • Q:

    How do I wire a double-switch light?

    A:

    Wiring a double light switch is a simple job that the average homeowner can do. However, it's important to use extreme caution when working with electricity. The required materials are a voltage tester, screwdriver, electrical tape, wire cutter, wire stripper and grounding wrist strap.

    Full Answer >
    Filed Under:
  • Q:

    How do you wire a three-way switch?

    A:

    Family Handyman gives instructions for wiring a three-way switch, which involve connecting both switches to the light that they control. Before working on this DIY electrical project, it's essential to turn off the relevant circuit at the electrical panel to prevent accidentally electrocuting yourself.

    Full Answer >
    Filed Under:
  • Q:

    How do you wire a basic light switch?

    A:

    To wire a basic light switch, turn off the power to the switch at the breaker, pull the wires to the switch out of the wall, connect the wires to the screws on the sides of the switch, and screw them down with a slotted screwdriver. Finally, test the switch.

    Full Answer >
    Filed Under:
  • Q:

    How do you wire a two-gang switch?

    A:

    To wire a two-gang switch, join the live wires with a single connector, repeat the same for the black and ground wires, and attach the wires to their respective terminals in the switch. Before you begin, disconnect the power supply to the room to avoid electrocution.

    Full Answer >
    Filed Under:

Explore