How to Replace a Prop on a Mercury 50HP.?

Answer

1. Describe the motor type, horsepower and weight and type of boat when purchasing a new propeller, or use the same number pitch propeller as the one that came off. 2. Remove the cotter pin from the propeller drive shaft using wire cutters. Remove
source: www.ehow.com
Q&A Related to "How to Replace a Prop on a Mercury 50HP."
A Mercury outboard motor weighs just over 200 pounds depending on the model number.
http://wiki.answers.com/Q/What_weight_is_a_mercury...
not enough information on the motor. what year and model? but all yamaha outboards are shut down by the C.D.I. being grounded by the key switch or the emergency kill switch. the cheapest
http://www.fixya.com/support/t10629359-set_timing_...
A base g50 hp has 2 GB of ram, but you can add another GB if you wanted.
http://www.chacha.com/question/how-many-gigs-of-ra...
Explore this Topic
±50hp at the wheel. ...
1. Disconnect the two wires from the motor to the wiring harness. Label the connectors on the wiring harness to facilitate their replacement. 2. Remove the grounding bolt and washer to the grounding strap, with an adjustable wrench. Remove the remain ...
Disconnect all power supply to the board, by removing battery. De-solder or remove the diode to be replaced. Make sure that you purchase compatible diode and install ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com