Tweet
Changing Front Struts?
Answer
To change front struts you need to first loosen bolts that secure the wheel. Then remove the strut assembly from the vehicle then install the spring and the strut bearing on to the new strut. Assemble the new strut then place it back into the strut tower and replace the tower bolts tightening the bolts securing the strut congregation to the steering knuckle and torque to the manufacturer’s requirement.
Q&A Related to "Changing Front Struts?"
|
1. Park the vehicle in a flat, level paved or concrete surface. Place the wheel chocks in front and behind of one rear tire. Turn the ignition key to accessory, to unlock the steering
http://www.ehow.com/how_4796969_change-front-strut...
|
|
1. Loosen the lug nuts on each wheel with the lug nut wrench. You should find the lug nut wrench in the hatch of your Honda. 2. Jack the Honda and place on jack stands. Remove the
http://www.ehow.com/how_5858992_change-front-strut...
|
|
Automobile struts help maintain stability and the quality of the ride. Monroe, a leading manufacturer of struts, recommends replacement after about 50,000 miles. This number can be
http://www.ehow.com/decision_6928396_should-front-...
|
|
1. Loosen the lug nuts on your front wheels, but do not remove them. 2. Raise your car, using the floor jack, by positioning it below the jack points that are behind the front wheels
http://www.ehow.com/how_7505034_change-front-strut...
|
Similar Questions
People Also Asked
Wikipedia on Ask.com
The MacPherson strut is a type of automobile suspension (vehicle) system which uses the axis of a telescopic damper as the upper steering pivot. It is widely used in modern vehicles...
Top Related Searches
Explore this Topic
When you are going to change the front strut on a 1992 Chevy Lumina, make sure you have all tools and materials ready to be used. Remove the the old strut and ...
1. Raise the car's front or rear end and support it on jack stands, then remove the wheels with the tire iron. Raise a floor jack underneath the control arm (front end) or the axle carrier (rear end) to support it. 2. Disconnect the stabilizer bar fr ...
To change rear struts on a 1989 Subaru GL, use wheel chocks to block the front of the wheels. Place a jack underneath to raise the vehicle's rear. Lug nuts are ...