Tweet
Changing Front Wheel Bearing?
Answer
To change the front wheel bearings on automobiles with disc brakes, the disc rotor must be remove first. Once the rotor is removed the bearing race may be slipped off the spindle and replaced with a new one. Replace the rotor and wheel assembly to complete the job.
Q&A Related to "Changing Front Wheel Bearing?"
|
1. Lift the front of the vehicle using the jack and secure it on the jackstands. Make sure that the front wheels are off of the ground and that the truck is secure before you crawl
http://www.ehow.com/how_5501969_change-front-wheel...
|
|
1. Loosen the front lug nuts on the wheel with the failed hub-and-bearing assembly, using a ratchet and socket. Raise the front of the HHR with a floor jack and slide jack stands
http://www.ehow.com/how_12225087_change-front-whee...
|
|
1. Jack up the car, using your jack. 2. Remove the front tires, using a lug wrench. 3. Unclip the brake pad wear sensor, located on the brake caliper. 4. Remove the guide pin bolts
http://www.ehow.com/how_5796039_change-front-wheel...
|
|
1. Open the hood and use a wrench to loosen and disconnect the negative (black) cable on the battery. Wait 90 seconds, to drain the energy from the air bag. 2. Use a tire iron to
http://www.ehow.com/how_6766755_change-wheel-beari...
|
Similar Questions
People Also Asked
Wikipedia on Ask.com
Front-wheel drive (FWD) is a form of Internal combustion engine/transmission (mechanics) layout used in motor vehicles, where the engine drives the front wheels only....
Top Related Searches
Explore this Topic
If you are changing the front wheel bearings on a 1998 Dodge Ram 1500 2 wd pick up, remove the wheels , and take the support caliper Slide rotor off. Remove the ...
In order to change the front wheel bearing in a 1996 ford explorer, you would need to first have all of the necessary tools for this type of job. If you are going ...
To change the front wheel bearings on a 2000 Chevy Cavalier you will need to remove the rotor, knock the outer seal from the back side (this is done by putting ...